Yes it’s quick and simple to use

Thanks and happy milling 🙏

Japp blir jättefin yta med kedjesågen. Betydligt finare än vad man kan få med en bandsåg.

Roligt att du gillar den 👍

Roligt att du gillar kanalen. Svaret är lätt har du tillgång till el så köp elsåg. Är sjukt mycket trevligare att såga med. Jag håller även prova på dagar hos mig. Då får man komma hit och såga så mycket man vill under en dag. Titta på facebook.com/sagverkskurs för mer info

Tackar tackar

Peter Simonis, I have an M8 and had the same problem. I solved it with several measures. I think they all had some effect, but not one single thing was 'the' answer. What I did: Bought a precision hand chain filing tool from Stihl; swapped to skip tooth chains, sharpened at no more than 10 degrees. This ensures the chain doesn't pull down or up, I installed (home made) bar nose steering (25" chain). I checked, double and triple checked the frame was square and flat in all directions, shimmed the chainsaw carriage and adjust with a set screw so it is perfectly level. I tried various chocks, wedges etc to make sure the log doesn't move. I find the original clamps very poor at holding logs with thick bark (oak, etc). Now I have beautiful boards. I found that grain direction and twist had NO effect on the trueness of the cut, but at first I convinced myself that it WAS the wood. It's not. It's mainly the design of the system. Logosol were not listening when I told them I had a problem, but look on YT and forums and you'll see anyone handling anything large or tough (not a perfect softwood 8 incher as always demonstrated by Logosol) has some versipon of this problem. It seems worse the more of a perfectionist you are! Good luck, it's well worth trying these things. With hindsight I'd go first for swapping the chain for narrow kerf, ripping skip tooth.

Yes I prefer the new saw. It use standard Stihl bar instead of a special bar

@@Projectoftheday Lovely, thanks for the reply... I'm planning to build one so trying to figure out which design to copy 😄

@@whirled_peas copy the ES5/ES8 design

Hello, you have great videos. I have idea to make electric saw because I have electric motor. May I ask you to share some information about type and diameter of pulleys on ES 5/8, bearing housing for Schaft, because I don't know how to put all that under the plate with 64 mm distance between table and plate. Thank you.

Kommer snart en uppföljare om allt går som planerat.

Spännande

Något speciellt du vill att jag tar med?