See it here: www.trick-tools.com/ProLine-36-inch-Cast-Iron-Planishing-Hammer-11539
The ProLine 36 inch Pneumatic Planishing Hammer is a floor standing industrial quality unit, based on the classic Chicago Pneumatic design, used for forming or planishing compound curves in sheet metal. It is used in many industries, including automobile and aircraft restoration, race car fabrication, sheet metal stamping shops, artistic applications, etc. A ProLine planishing hammer takes the work out of metalwork and saves the experienced metal worker hours of time, leading to increased production.
One huge advantage in the design of the ProLine hammers is the foot pedal activation. By pressing the foot pedal down once the material is in place, you bring the dies together and start the air motor in one step. This not only allows for easy removal of your part when open but gives very precise control of the pressure and allows for feathering off at the end of a shape. This is not possible with most planishing hammers that have a fixed die gap. The lower arm on these cast iron floor models can be lowered to accommodate an optional bottom anvil holder for deeper parts. They feature heavy-duty purpose built pneumatic motors and sturdy cast iron frames. A needle valve allows for fine tuning of power output and an automatic air cutoff switch shuts off air to the motor when the foot pedal is up.
These hammers are completely fabricated in the USA. If you are looking for uncompromising quality, then you have found it with ProLine, the finest planishing hammers on the market today.
Trick-Tools.com
Sales@Trick-Tools.com
1.877.VAN.SANT