Great video. I have that exact Kennedy box...love it. Mines loaded up with Vw van tools. Ha. Awesome electrical box cover
@thosearentoars3 жыл бұрын
That table is huge, you could slice up a Buick on that thing, you must be having a lot of fun with it.
@flatheadronsgarage73453 жыл бұрын
Thanks for sharing. It’s over my head but you had me interested the whole way.
@kannonshane87483 жыл бұрын
A tip : you can watch movies on Flixzone. Been using it for watching a lot of movies lately.
@enriqueruben48913 жыл бұрын
@Kannon Shane Yea, I've been using Flixzone for since november myself :)
@kingstonmalakai59103 жыл бұрын
@Kannon Shane yup, have been watching on flixzone for since december myself :D
@OldIronMachineWorks3 жыл бұрын
Very nice Doug
@divalmusicstudio31293 жыл бұрын
Donde consigo el THC PROMA?
@metalworksmachineshop3 жыл бұрын
www.shop.cncdrive.com/index.php?productID=462
@brunick6833 Жыл бұрын
So I watch all that and you don't show how you hooked to your breakout board and that's the part I wanted to see lol
@metalworksmachineshop Жыл бұрын
I have the gecko 540 controller , if you don't have that the wiring wouldn't be the same probably
@aitoussismail68252 жыл бұрын
, I found that the THC is sending a signal for UP or DOWN but the Z axis is not moving. In test mode, it goes up / down. what's solution?
@metalworksmachineshop2 жыл бұрын
Does the torch just go up slowly? The amps are set to high on The Proma. When it's cutting what amps are showing on proma? And what do you have the porma set at?
@aitoussismail68252 жыл бұрын
@@metalworksmachineshop you can give me numbre whattapp