Proximity Switch - Introduction, Wiring and Testing

Рет қаралды 31,422

Жыл бұрын

This video shows you the proximity switch used in industrial machines, CNC machines, and other applications. I introduce you to the proximity switch, show you how to wire the proximity switch, and then configure the proximity switch for Mach3.
The equipment and software shown in this video can be found at:
www.buildyourcnc.com
Mach3 Software:
www.buildyourcnc.com/item/con...
Proximity Switch:
www.buildyourcnc.com/item/ele...
Mach3 USB Controller:
buildyourcnc.com/item/electro...
Pokeys57CNC Controller (Mach3 and Mach4):
buildyourcnc.com/item/electro...
24 Vold DC 1 Amp Power Supply:
buildyourcnc.com/item/electro...
My thorough discussions on switch bouncing.
• 12. How to Create a GP...
• 13. Arduino for Produc...
#cnctutorial #cncrouter #proximitysensor #proximitySwitch #limitswitch

Пікірлер: 23

@lamvprtube Жыл бұрын

Thank you for taking your time and making these informative capsules. Many of these pieces arrive without instructions. I ask him what happens if we use normal and closed. I ask what happens if we use normal closed proximity switch.

@jimihills125 3 ай бұрын

thankyou great video sorted my problem on my printer switch was too far away from, the metal

@shelleykarijoredjo8421 Жыл бұрын

Well explained

@abtappy1190 Жыл бұрын

Thanks

@abennacerboulaghmane121 Жыл бұрын

Thnx for thé vidio pro it is useful

@PatrickHoodDaniel Жыл бұрын

Thanks!

@umargul5644 Жыл бұрын

Great

@checktheskies5040 Жыл бұрын

What about using aluminium as the trigger metal?❤

@chongshenchang9367 Жыл бұрын

Sir, can you please explain with schematic diagram and components used in electromagnetic accelerator using this sensor which rebel the ball bearing away when it reaches near the inductive coil from it. I needed this for my science project in my college. Please...

@olufemisotunde3868 11 ай бұрын

Need more explaination when having mutiple proximity on each end . Can they be connected in series

@PatrickHoodDaniel 11 ай бұрын

Yes, they can, and I will probably make a video on this. As long as the proximity switch is NC type, the switch can be connected in series. As long as the switch is getting power to enable the sensor, the output signal works very much the same as a typical mechanical switch.

@olufemisotunde3868 11 ай бұрын

@@PatrickHoodDaniel can photoelectric sensor be it used for CNC machine. Br100-ddt sensor .I have some in the factory remove from a scrap machine

@cnc_workbench Жыл бұрын

sooooo what happens to the pokeys57 inputs running 5v logic when your prox switch is inactive and you pushing 24v into it?? im hesitant to try as i dont wanna blow up the board.

@PatrickHoodDaniel Жыл бұрын

I didn't make that clear in the video. You would need to use a 5v proximity switch. We have those in stock and will be adding them to that page. Thanks for pointing this out.

@toddroles3234 10 ай бұрын

@@PatrickHoodDaniel. I don’t see the 5v proximity switches on your site. I guess I need to buy a level shifting optocoupler to reduce the voltage from switch down to 5v?