I have problems to calibrate my Z Axle and doing my X Y Z calibration.
Пікірлер: 14
@americohagim11314 жыл бұрын
Ahhh! Those sounds are giving me PTSD!
@thorley19834 жыл бұрын
the xyz calibration will fail if the machine is stealth mode. reboot, say no to the wizzard, and go into settings and click mode to change it back into normal mode.
@americohagim11314 жыл бұрын
Chris Thorley does that really work? Imma take your word for it and test that out
@HS-hz4fx2 жыл бұрын
hi, when z is 0 does nozzel touch the bed ?
@zayarln5 жыл бұрын
Did you assemble E3D Hot End assembly? If so, Check the whole height. It should be 62.3 mm. If not, correct it. OR, You can lower #define Z_MAX_POS value in firmware and upload.
@nowgogetyashinebox28492 жыл бұрын
I’m having issues calibrating my mk3s after changing e3d v6 hotbed
@Ronny_van_Gerwen4 жыл бұрын
I have the same problem here and a 2 days worth headache
@RobertBlow5 жыл бұрын
Did you ever solve this please. I have very similar issues. Thanks
@Polomaniac865 жыл бұрын
Yes, Change the Rambo.
@dzitiatrihrmb69674 жыл бұрын
@@Polomaniac86 are you jooking? You mean the motherboard died ?/
@Polomaniac864 жыл бұрын
@@dzitiatrihrmb6967 No, i sent the printer back to Prusa and they changed the Rambo
@dzitiatrihrmb69674 жыл бұрын
@@Polomaniac86 Michael Kraus You won't believe me. I have this headache for 3 weeks, first I thought pinda, readjusted it 2 times. Then reasembled x axis, changed idler bearing, belt tensions, tried reseting the printer settings a few times, then changed to a new pinda. But it was the same, stucking on xyz calibration. I almost give up and went for a holidays, but then I analyzed and found a new 3.9 beta firmware. I installed that beta and woho miracle happened. XYZ calibration done from the first time !!! Now it works like new.
@melaniaslatan11772 жыл бұрын
You. Changed the flex plate. It should use only the original.