Was exactly the same as my a Gravely Pro-Stance mower. Very helpful video!
@kevinwhite18322 жыл бұрын
I really tried to watch and learn I got so damn confused trying to follow you omg
@mom2bels7 жыл бұрын
Super helpful! My switch is similar, but noting like other switches I have seen videos for. Thanks!
@tetreaulthank40682 ай бұрын
Thanks for sharing
@zippahead7 жыл бұрын
I have a simplicity coronet rear engine mower. The PTO switch has six terminals, but my harness only has four wires. Can you help which wires go where?
@Aaronmiller496 жыл бұрын
My RZT 50 Cub cadet will engage blades with one lever but not the other Is there a switch somewhere
@justice4all9972 жыл бұрын
Movers starts good however once I engage pto switch mover turns off. Blades won't move
@randybeard60405 жыл бұрын
Before you Check the Switch Pull Input wires to Clutch and Check Ohms. on Clutch--Low Ohms-below 1 Clutch Bad--High Ohms-2-4 Clutch OK...
@BrianLaverdiere6 жыл бұрын
The mistake you made with the terminals was just the correction I needed. Thanks!