How to turn off the bottom light...ours wont reset
@GTXHD4 жыл бұрын
ptr baler be like brrrrrrrrrrrrrrrrr
@cynthia381714 күн бұрын
How can I push out the very last bale of paper without starting a new bale of paper?
@kcimagewrecka4 ай бұрын
So why wont my "full bale" light go off?
@splashcardoso5 ай бұрын
Costco uses two of these balers
@amrinder2899Ай бұрын
Do you guys have tire baler available?
@Gabrielcardboardbaler-yo3hv Жыл бұрын
Everyone has been talking down in your in the comments
@GABEsCHANNELSPANELS-MOTORS999910 күн бұрын
Say hi to maren
@DeadincardboardbalerGabr-kh6mb Жыл бұрын
Thanks for this baler
@Gabrielcardboardbaler-yo3hv Жыл бұрын
HEY MIKE SAVAGE
@babykicker2365 жыл бұрын
Does anyone know if it damages the cylinder to leave the ram down? Thanks
@katieducky234 жыл бұрын
Only if u constantly try to force it down after the downward cycle stroke has stopped automatically.
@stupid473 ай бұрын
Nah. I used an older model at my first job. At times, the ram was left down to compress the cardboard, and after a little time, it could be pressed once or twice more to compress the cardboard a little further, maybe a couple of more inches. That machine was robust and never broke down. A good tool to have, though, is a straight steel ramrod with a pointed end to poke holes in the cardboard when feeding in the bale wires. Sometimes, cardboard would block the wire slots and it was necessary to ram holes.
@Gabrielcardboardbaler-yo3hv Жыл бұрын
PTR Baler and compactor one of these days I’m gonna call my Baler New York northern recycling is it gonna be big Balers don’t do anything if their is a bale if there is below to the other arrow is still not safe will damage the chamber door in the feed gate in the middle no, if you was above the arrow, it was damaged the feed gate ,blows up the motor and breaks the hydraulic cylinder and all the oil will come out how much charge in the Baylor about 9090 9090 so I gazillion a gazillion a pressure in the Baylor you could compress anything in there you want