It is fine to leave it on the stand. I use a cut off 2 liter pop bottle to drain the oil into. Hold it up close to the drain plug, remove plug, after it gets to where it is just dripping, set the cut off bottle on the floor. The drips will not hit the stand. Make sure the washer is good, or replace it. It won't do any good to put Loctite on the plug. The threads in the case are covered with oil, so Loctite won't work. I use a 1/4" drive ratchet and just barely snug it up. The E50 uses Type F ATF. No need to measure it. With the moped sitting on the centerstand, pour fluid in the filler hole until it reaches the top, and put the plug back in. I welded a piece of a large diameter washer onto the end of a screwdriver. It is wide enough to prevent chewing up the slot in the plug. Clean up any spilled oil. I use spray carb cleaner or brake cleaner to clean the plugs, and around the plugs before removing them. SAVE THE PLANET!!!!!!!!! CRUSH A TESLA!!!!!!!!!

cooles Video werde es nächste Woche an meiner Oma ausprobieren

YEEEEEEEEEEEEEEEEET

Very good trans(m)itions, I'd even say they were fluid, almost like they were lubricated properly.

3:56 CUP

Joey was Here!!!!!

Instead of having to meassure the oil, just let the moped rest in a straight position and fill oil untill it comes out of the oil fill port. That's the amount you need. Easier and less mess. Even the original manual said to do that.