John McKelvie and Wayne Plata, from Griswold Pump Company, show how to set the impellar clearance on a Griswold 811 ANSI centrifugal pump.
Пікірлер: 10
@TheBadddSanta11 жыл бұрын
How come you didn't address total travel?
@elpaso99111 жыл бұрын
Any tips for removing a stubborn (stuck) impeller from the shaft?
@Posibrian2 жыл бұрын
heat it up
@michaelcox32952 жыл бұрын
Use brass and a 4lb hammer had one last night
@PilgrimPiperАй бұрын
@@Posibrian Be careful doing this as there could be a trapped vapor pocket. Peaceful days to you
@rabahsaim85432 жыл бұрын
Bonjour Je voudrais faire une formation accélérée (payante ) sur les pompes pouvez vous m'orienter ? Merci
@Dwainpipe2111 жыл бұрын
Impeller is set 15 thousands degrees off the front of the case ???? I think you mean 15 thou of an inch! lol .How come you fit the set screws to tapped holes in the bearing frame/power end/ adaptor used when separating the pump casing if it sticks?, you can just use one of the casing screws you have removed. Nice rotating table tho that makes things easier