Ford Escape - Reset / Clear TPMS Tire Pressure Light (2008-2012)

Рет қаралды 108,422

3 жыл бұрын

Step-by-step guide on how to relearn / remove / train TPMS Tire Pressure Monitor System Light on Ford Escape SUV ( 2008 | 2009 | 2010 | 2011 | 2012 | XL | XLT | LIMITED | HYBRID ).
This procedure of clearing and resetting tire pressure sensor fault message is meant for Ford Escapes with standard ignition. If you have a push button start, process to enter tire learn mode is a bit different. I will make a video on that once I get an Escape with push button start. Inflate all tires before starting the tire training. You will need a tpms diagnostic tool to complete the tire relearn.
Follow this steps (as shown in the video):
1. Insert the key into ignition lock, press and release the brake pedal
2. Turn key 3 times from OFF to RUN and leave it in RUN position
3. Press and release the brake pedal and turn the key to OFF position
4. Turn key again 3 times from OFF to RUN and leave it in RUN position
5. Horn will sound which means you are in train mode
6. Use diagnostic tool to train each TPMS sensor starting from driver front side wheel
7. Horn will sound after each TPMS sensor is trained, once you complete all four training is done
8. You will get a message Training Complete!
Thanks for watching.
Don't forget to Subscribe and Like if this video was helpful!
⚠ DISCLAIMER:
While QuiteAlright strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. The videos are intended for information only. Follow the manufactures repair procedure and use appropriate safety procedures. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. QuiteAlright is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Пікірлер: 50

@jjoliet79 Жыл бұрын

What on earth!? What genius came up with this procedure? Do I need to rub my belly and pat my head at the same time?

@dwaynekittelson1288 Жыл бұрын

"Jesus christ, I'm not sure how this is possible" haha such an unexpected turn in a basic instructional.

@juanflores-qq6xx 2 ай бұрын

Thanks for your help at support God bless you

@QuiteAlright 2 ай бұрын

Happy to help

@hopejohnson7145 10 ай бұрын

Thank you

@QuiteAlright 10 ай бұрын

You're welcome

@CloutTheGoat 7 ай бұрын

You don’t need a scanner just turn the car on once the light starts blinking give it about 10 minutes and it will reset on its own

@Luketube3 29 күн бұрын

Yeah just waited about 5 with the car running then the horn honked twice and light disappeared

@AntwoineWashington 27 күн бұрын

@@Luketube3that really worked ?

@ashkagarice4058 Күн бұрын

Does it still work without the scanner if when you turn the car on it says train left front tire?

@tiatonchis Жыл бұрын

thank you

@QuiteAlright Жыл бұрын

You're welcome

@joserivas2992 Ай бұрын

TMS sensors can be expirated they have a life span average of 8 years after that no scanner can erase that code unless you replace the battery dead sensor.

@user-jr1tw2cy9h Жыл бұрын

Дякую, все вдалося Ford Escape 2018. Tnks

@QuiteAlright Жыл бұрын

You're welcome

@irstgoop Жыл бұрын

So where's the button on the steering wheel?

@roulamerheb2468 Жыл бұрын

To reset it we should use the scanner or we can without it ? thanks.

@QuiteAlright Жыл бұрын

Hi, you can try to relearn each sensor by releasing the air from the tire, but that works only sometimes. If not you will need a TPMS scanner

@Conetopiatv 2 жыл бұрын

[Warning] Just thought I would mention that if you have 3 lights on your dashboard. TPMS , Brake-Light , Door-Ajar. ( Mostly at the same time ) You have an Instrument Cluster Loose Connector issue. This Causes Intermittent activity, causing the lights to turn . If you Hit/Smack/Tap the Plastic Shield in front of your Speedometer , the warning lights will turn off. ( Same as if you hit a decent size bump in the road ) Note: That a loose connector will lead to the Instrument Cluster ( Speedometer ) lights to stay on 3 minutes after you lock your vehicle. Also: your A/C will not blow cold air until the Instrument Cluster connector issue is fixed.

@QuiteAlright 2 жыл бұрын

Thanks for sharing your knowledge. Definitely good to know

@CaptainGoosee 2 жыл бұрын

Thank you so much

@1islegirl Жыл бұрын

How do you fix the problem with all the lights coming up on your dash board?

@XCircaX 2 жыл бұрын

did you rent that tool from napa?

@QuiteAlright 2 жыл бұрын

Bought mine at Napa

@mrbruns2619 Жыл бұрын

Tire shop did this with no fix and now my dome light flashes on and off constantly. Anyone have thoughts on this?

@QuiteAlright Жыл бұрын

Hmmm that's strange as tpms and interior lights are not connected. Dome lights could be a wiring issue. Try taking it apart and inspecting the bulb and all connections. IF TPMS reset didn't fix your problem and all sensors are reading + tire pressure is good then you might have a problem with the module itself

@queenbderbest2454 11 ай бұрын

Having the same problem have to go to Ford dealership tomorrow to reset🙄🙄

@mrbruns2619 11 ай бұрын

@queenbderbest2454 Ford diagnosed my 2007 hybrid. Said their computer wasn't able to speak with module BL8Z-15604-B. Which deals with the TPMS and many other things, including the stereo. Not sure about the dome lights. Haven't got around to replace said part to see if this fixes the issue.

@JR-bi8iy 8 ай бұрын

The tire shop you took to, preformed incorrect procedure. Walmarts tire shop did this to me as well, they didn't perform what this guy did in video and kept trying using the the tool and under dash connection. Tell the shop you took to, to oreform it this way and it will fix everything only if all the sensors are working correctly and are the ones required for it.

@kato223 2 жыл бұрын

That is great information to start, but couldn't you just over inflate the tires by a couple of pounds, then go through letting pressure out of each tire to get them to train? I thought you could.

@QuiteAlright 2 жыл бұрын

Theoretically that could work, unfortunately never worked for me on all 4 tires. But it's worth a try

@Lukie2131 Жыл бұрын

Will this work on a 2007 escape?

@QuiteAlright Жыл бұрын

It is the older body line but I believe the process should be the same

@markusaurelius777 8 ай бұрын

@@QuiteAlright Will this work on a Ford Escape 2011?

@QuiteAlright 8 ай бұрын

@@markusaurelius777 Yes it will

@annette5208 Жыл бұрын

Will it effect battery?

@QuiteAlright Жыл бұрын

The car battery? No it will not

@annette5208 Жыл бұрын

Thankyou for reply I appreciate it

@QuiteAlright Жыл бұрын

@@annette5208 You're welcome :)

@MrFragManiac Ай бұрын

Can you at least steer us to what $50 tool you were referring to? None of the ones I saw on Amazon were at that price. You have to pay hundreds of dollars just for the ones that have a built-in display.

@lilsyrupshawty 6 күн бұрын

obd2 scanner, I paid 40 cad for mine. comes with a screen.

@MrFragManiac 6 күн бұрын

@@lilsyrupshawty I ended up going to Discount tire. They replace all 4 TMP sensors for $60 each, and don't charge for labor, and warranty them for 6 yrs.

@davontescott4121 Жыл бұрын

what about 2007 Ford escape

@QuiteAlright Жыл бұрын

It is an older model so process on how to get to the tire learn mode could be a bit different. But it should be the same or very similar. Once activated part with the scanner will be the same

@matthewdupuis232 Жыл бұрын

One tire 49 psi, one tire 24 psi, low fuel light on. Diagnosis: your wife's car.

@roadrageYXE 2 ай бұрын

Save your time. At 1:30 he brings up- oh yeah you need a scanner for this to work.

@erickyryliuk4495 Жыл бұрын

When I scan the right front tire the horn beeps twice and the dashboard reads "tires not trained - repeat" How can I prevent this from happening?

@QuiteAlright Жыл бұрын

Hmmm I never had this happening, but I guess the RF tire sensor was not read properly and possibly there is a problem with it. Can you read the sensor without doing a relearn and does it pass the readiness test?

@briancunningham7839 Жыл бұрын

The sensors have batteries in them that run out after about 10 years or so, so if they're dead that might be why its not communicating with your device. Unfortunately they're not super easy to replace, so I'd recommend waiting till you need to replace your tires and trying to convince the shop you're buying from to add that in for you