Рет қаралды 4,739
Inspired by #Märklin #39777, I found my old #zeppelin #3077 (model based on #Kruckenberg) and revised it. This video shows the steps.
Shopping List:
1 x 3077 Rail Zeppelin
1 x decoder of your choice for #MFX, #M4, #MM, #DCC
(e.g. from #ESU, #Lenz, #Maerklin, #Tams, #Uhlenbrock, #Zimo)
at least 6 outputs:
5 for light and 1 for propeller engine
51961 Hamo Magnet (ESU) or similar
2 x Duo LED DT0605RWM
1 * LED Tape
3 x 1kOhm resistors
2 x Zener diodes 4.7V or 1 x 9.1V or 10V
several seats and figures for interior decoration
Chapter
0:00 Introduction
3:07 Disassemble
4:15 current measurement at the propeller motor
6:15 Removing the interference suppression capacitors
8:00 Planning interior design
9:15 Removing the windows and highlighting the struts
11:31 Interior design is created
15:00 circuit diagram
20:20 Placing the electronics and laying the cables
24:00 Bonding of the LEDs
25:45 remaining assembly
26:35 first test drive with obstacles
28:46 the solution: zener diodes!
30:49 Programming of the decoder with the ECoS
46:26 driving videos