Рет қаралды 232,535
In this video, I use a basic Tire Pressure Monitoring System (TPMS) tool re-learn tool to re-program my TPMS in my 2019 Chevrolet Impala.
The TPMS re-learn tool I used is an Augocom EI-50448, though there are many identical looking ones out there.
Planning to buy online? Sign up with a cashback site first to get a rebate (typically 2-5% of total cost) from tons of retailers! Plus, get a bonus on your first purchase (bonus amount changes from time to time)... below are the sites that seem to have the best cashback now:
USA Signup: www.topcashbac...
Canada Signup: www.rakuten.ca...
Amazon.ca : www.amazon.ca/...
Amazon.com : www.amazon.com...
For anyone else with a 2014-2020 Impala (likely very similar procedure for other GM vehicles), here is how to do a TPMS re-learn:
1) Enter diagnostics mode by holding the ignition start/stop button for 5 seconds (do not press the brake pedal)
2) Find the tire pressures page on the dash display
3) Hold down the ‘checkmark’ button on the steering wheel. The horn will sound twice
4) Go to the front left tire. Position the TPMS tool near the valve stem and hold the button until the horn beeps
5) Go to the front right tire, and do the same thing
6) Go to the rear right tire, and do the same thing
7) Go to the rear left tire, and do the same thing
8) The horn will double beep to indicate success. Turn off the ignition, start car, and you should be set!
Note that you may need to hold the button for a while... it took close to 30 seconds to pair the first TPMS sensor. Just hold the button until the car beeps at you at each wheel.
If you found my video useful and would like to support me, thank you! You've got a few options:
- Subscribe to my channel
- 'Like' the video
- Sign up with a cashback site using a link above
Thanks