No parts required! You will need carburetor cleaner or acetone and compressed air. "Enemy Ships" by Audionautix is licensed under A Creative Commons Attribution 4.0 license. creativecommons.org/licenses/... Artist: audionautix.com/
Пікірлер: 15
@donaldmacqueen7550 Жыл бұрын
Very helpful. Got mine cleaned up in less than an hour. Thanks.
@harrystanley1651 Жыл бұрын
Excellent Video, very detailed and helped me clean up my carb on my 27-year old HR214. Thanks a lot.
@davidgpo Жыл бұрын
Thanks for watching!
@jdkrxw9 ай бұрын
Good video. In a pinch, the main jet can be taken out and cleaned without removing the carb. This solves 90+% of fueling problems. Remove the bowl and find a flat blade 1/4" screw driver bit that's about an inch long. You can use a bench grinder to get the shape that works, and use a 1/4" wrench to turn it.
@davidgpo9 ай бұрын
Thanks for the helpful tip and thanks for watching!
@normanbfifteen3468 Жыл бұрын
Man I must say...you have patience... you did all this with mower on the ground.
@davidgpo Жыл бұрын
Thanks for watching!
@dearthworm3 ай бұрын
FYI. Shutting off the fuel and running the engine until it stops does not eliminate all fuel from carb. The float bowl will still have gas in it. You need to drain the bowl using the drain screw.
@glennkubik377411 ай бұрын
Quite sure Gasoline breaks down Silicone, gunky residue. But very good Video 👍
@davidgpo11 ай бұрын
I believe that you are correct. Thanks!
@routtookc80642 жыл бұрын
The plate sitting on the front of the carb, was it flat? I have mine apart and the plate has a slight curve to it.
@davidgpo2 жыл бұрын
It is flat.
@routtookc80642 жыл бұрын
@@davidgpo thanks
@dominikwojtas2550Ай бұрын
Hi , that's amazing content!! Your not smoke at all!!! Change you piston rings allready? Greetings from Poland 😉