Done it! Took just over an hour. Quite a fiddly job. So glad it's done.

That is an excellent instruction video as well as visuals of the procedure. We were successful due to this video

True to my usual form, a simple repair became a hassle when I lost one of the ball bearings.

Really good video,no bs to sit through

Excellent Instruction!

Excellent video. Thanks!

Very helpful and professional video! Not sure about the Collingwood hat though 😆

Just finished doing my SY territory ignition. A little fiddly but quite easy.

Man...how hard is it to remove push those hoising pins out and then get them back in again. If i had've known this first i wouldnt have attempted it lol

My 07 terri sy wouldnt crank when in town (ing lights on) Swapped fuses relays and found bridging start relay would crank and run. Drove home and found wiggling key in start would start it, but then key lost detents an a ball bearing fell on my foot.... looks like will have to rebuild as per this video. One other fault before total fail was fan aircon stopped working and radio turned off but I could turn on. Thanks for this video, quicker than opening workshop manual.

Where do we get the ignition switch removal tool from?

Great video! Thanks for sharing! Any links where to find the switch extractor and the new switch parts? Thank you!!!

Just wondering where you can get the new housing from. I'm in nsw, thanks

Exceptional vid mate kept simple and clean very professional thank you for sharing this knowledge

Thx. Very good

Oh for the want of two allen screws instead of the pins...

Where can you buy the kit from and what is it called?

Great video young fella! Could you recomend anyone in Darwin to do this job for me? The copper plate and stuff just fell on the floor of my ute. Cheers

I found the ignition didn't click into on and acc like the original. key now feels like turning porridge . very expensive for what you get

Anny help where can i find buy the removal tool?

I've tried to call to purchase phone is never answered are you guys still in business?

If it was designed properly from in the first place wouldn’t have to do this shit

I just buy a spare whole wheel assembly with keys put in get coded $50

This is not the same tool i recieved nor did the insttuctions match the tool i recieved & as theres not a sufficent flat spot on the coated alloy housing whos the genius that forgot this shit slides every fkn where

Just did mine, in all of about 30 minutes. The removal tool is an engineering masterpiece, unlike Ford and Bosch's disgusting engineering of this switch. Definitely be sure to have nice long pin punches on hand, otherwise it will be a painful task. The rest is easy if you follow the instructions closely and take your time with it. Screw Ford for poor quality components. Makes me glad they shut down the Adelaide factory.

What a stuff up Ford made to make what should be a simple job hard for the home mrchanic...give me an old falcon any day...taking out the barrel from the dash is a 5 minute job..BA and BF Falcons are such shitboxes ill never buy another one !!!