Holy cow. I know I’m an idiot for doing this but I put a tiny Phillip bit that would go on a chuck or in a bit holder in there and it was jammed in there good. I couldn’t even pry under it. So what I did was, hear me out, I used a hammer to bang down the tip some, I used some pliers and was able to get a grip on it and pull it out. Thanks for the video my good sir. Now hopefully I can get it reassembled and never make that mistake again

Thanks for doing the video I snapped a Hardor freight unibit off in my impact and haven't had the tool useable since

I just used your method it worked a treat with a Macallister impact driver. I liked the tips of using grease on the ball bearings (mine had three) and the tool to catch the parts. Many thanks.

Will attempt this on my makita tomorrow am .best vid I've seen for this exact problem .thanx.

Right on brother I follow your directions it was super simple the bit in the top save my spring from shooting out one time and other than that your direction to where spot on I will follow you

Great job thanks. Can fix mine now.

Just did this on my new makita! Thank you so much.

Great job!! Thank You!

Thanks for making this video sir

Good job sir 👌👍😎.

Hello, I was available to remove the spring and the other two rings but the black part that you pull to remove the bit it doesn’t come out

Thank you I got my bit end unstuck with your help! ❤️

Good video just had your camera the wrong way so picture was small.