Our tech Tom shows the proper way to remove the control board on a Quiet Gasoline Control board.
Пікірлер: 13
@dealershipcallcenter4 жыл бұрын
Appreciate you letting me cancel my order (ebay yesterday) for the wrong control board, you guys are on my 5 star list!
@dannyrusso8279 Жыл бұрын
Just got your replacement board for my 4K Onan, which would only run when the starter was depressed. It was showing a #45 error code. After installing your board the generator started right up and is making good electricity. Thanks!!!
@petermacdougall5 ай бұрын
I am watching this video to see how to remove the control board because it is in the way of me cleaning the ground wire that is sparking and causing my generator not to turn over. I think this happens a good bit in older generators.
@rickboretirementplan5 жыл бұрын
I removed my 4000 yesterday and today I find this video.
@jodymiller5862 жыл бұрын
What are symptoms of bad gas control board
@daisygirl53686 ай бұрын
I have a 4000 spec P ONAN in my class c.the generator runs fine charges the batteries but when i turn on the AC it sputters and turns off. i can run the generator for hours but as soon as i add extra load water heater and the fan in the ac it shuts off. i can dump the extra power and it starts right back up ???
@dbakerhunter8426 күн бұрын
Same with mine. Seems my rings are corroded. I took ohm readings and they are high. Now I have to remove the generator and figure out how to disassemble it to clean the rings. Wild how something can be made so poorly
@Letsgobrandon-h7w2 жыл бұрын
do they go out ever?
@isidroastorga1343 жыл бұрын
My generator run 20 to 30minutos and lost signal to carburador sol
@isidroastorga1343 жыл бұрын
The control board send volt to carburador sol
@mft19763 жыл бұрын
Is the control board and voltage regulator on an Onan Microquiet 4000 the same unit??? I have the same control board as in this vid. I just don't know where the voltage regulator is located. My genny won't stay on when I release the start button. It will stay on for about 10 seconds if I hold the start button pressed in. After that, it will die and throw code "3-2".
@jimpawlecki88403 жыл бұрын
Win currently having same problem. What was the fix? Please email me jimpawlecki@gmail.com
@BMWontrack4 жыл бұрын
What are the symptoms of a bad control board? I am chasing very bad voltage noise & distortion (DIRTY power) and can't seem to find the source. New brushes and slip ring cleaning did not solve the problem.