Short clip demonstrating how to ALMOST always remove a broken orfice tube.
Пікірлер: 2
@FtWChevyTruck Жыл бұрын
Thank you. I ran in to this today, going to get my propane torch out in the morning. This is real tech, its simple if you know how to do it, I fished at broken one for an hour today. I was ready to replace the evaporator
@Normandy1944 Жыл бұрын
So, here it is 3 yrs later and I found your tip and applied it and worked like a charm, thank you. Though on a C4 Corvette, it is a circus scenario. I applied needle nose vise grips beforehand and applied the heat and worked it out. As tight as the getting in with the torch is, I was afraid to lose the heat before I could get the pliers on it again. Plus I didn't want to get it too hot for the plastic casing it runs into and the wire casing. Hopefully this helps someone else out with a C4 Vette and may be afraid to try this. Just make sure you remove the connecting line completely to remove interference.