REMS Mini-Press with Yorkshire Xpress fittings. No more soldering, no flux, works on wet pipes. For Gas & Water. www.LondonGas.... www.LondonGas....
Пікірлер: 12
@colinblythe37104 жыл бұрын
Hi Thank you for posting this video it gave me a good idea to the actual size of the machine - do you know if the "REMS" jaws work with other manufactures tools - eg novo press or rothenberger ?? - thanks again
@TradesDigital4 жыл бұрын
As far as I'm aware the REMS mini press jaws only fit the REMS mini press.
@colinblythe37104 жыл бұрын
Ok thanks for the reply and your time
@Cratos984 жыл бұрын
@@TradesDigital yes you are right about Mini Rems but the normal Rems work to other brand's also. cheers
@pedroluismendozaarivilca8673 жыл бұрын
Bello come aiatema
@juancarlosllacchuasotelo17564 жыл бұрын
Como calibrar press fitting o cabezal como lo llamamos en peru k herramientas se usa ya k lleva unos resortes internos...
@LondonGas2 жыл бұрын
Sorry Juan, I don;t know how they are calibrated. I'd send it to a professional for servicing and calibration.
@steDsherry Жыл бұрын
What's it like on actual Installs tho in tight areas
@LondonGas Жыл бұрын
It requires a little pre-planning, compared to soldering. Sometimes have to crimp fittings in a different order, where space might be a constraint. They sell an additional 45° jaw adaptor for hard to reach places - called the Z8 Here's a link www.angliapipetools.co.uk/product/rems-z1-mini-press-adaptor-for-45-degree-578558/ Don't think I've ever had a fitting on site that I've not been able to use the mini press
@b21playa2 жыл бұрын
What’s the cost of this?
@LondonGas2 жыл бұрын
For the REMS mini + 3 tongs, battery, charger and case cost £895 + Vat That was is Sept' 2016. Cost around the same amount to buy stock of pressfit fittings.