He we have a common bench high current power supply commonly used with High power RF amplifiers & land mobile radio systems, Ham Radio transceivers & electronics applications. these use 5x 2N3055 series pass transistors with 0.1 ohm emitter balancing cement resistors to provide a max output current of 30Amps, the supply is rated to 25 Amps continuous. Using electronic fault finding principles We confirm the fault, look at the safety concerns when working on the power supply, theory of operation, & discuss the configuration & architecture of the PSU bearing in mind we have no circuit diagram or service manual we have to reverse engineer the system to understand its theory of operation.Following this we discover a defective power transistor & begin pinpoint measurements of the collector, base & emmitter junctions to confirm their status of each of the 5 transistors. we isolate the suspected component & verify the defective transistor ensuring there isn't a secondary fault. Upon reassembly we discover another issue with the ammeter on the front panel having its bezel moving unrestricted due to the glue holding it in place breaking down, we re glue both the ammeter & voltmeter bezel & re assemble. Last step is a confirmatory test to ensure all is well before considering the repair sucessful.