Repair: OS FS 40 - New bearings
Рет қаралды 2,890
4 жыл бұрынI removed the bearings from the engine (they were really ugly) and install new ones.
#repair #nitromotors
@EnglishTurbines 2 ай бұрын
Did you scribe an x on the conrod and piston top before removal is the big question...?....🤔🤔😏😏😏🇬🇧
@andresramirez-mp5zc 8 ай бұрын
Great video!. Are bearings with plastic retainers ok?
@Ramztothaz Жыл бұрын
Put the bearings in the freezer before installing. With frozen bearings and a heated bearing seat, they will basically fall right in.
@VintageTechFan Жыл бұрын
Tried that a few times. It works great with the big ones on the crankshaft, but the small camshaft bearings have so little heat capacity that they are back to room temperature basically immidiately after taking them out.
@homienat3374 Жыл бұрын
What about valve clearance???? After rebuild????
@homienat3374 Жыл бұрын
You wreck the engine
@twincam825 Жыл бұрын
At frame 19:49 looks like rod is install wrong bevel of rod should go towards crank.
@billjones3071 Жыл бұрын
Use a piece of wood to bang in the bearing, more heat and some oil
@homienat3374 Жыл бұрын
You didnt event set timing ,totally wrong
Mark Robinson
Рет қаралды 11 М.
MAMU TECH
Рет қаралды 263 М.
Immersed
Рет қаралды 58 МЛН
EZ-GLAZ
Рет қаралды 22 МЛН