Thank you for this. I have a 410D and re built half my motor and hydraulic pump ect... Next i need to replace almost every pin/bushing in the thing.

Thank you for the video before I beat it into submission lol. The red ring is most likely to help keep the new seals from getting damaged when installing the assembly 👍

That little red thing is to get the snap ring out push your gland and snap ring in put the plastic half ring in the groove pull everything out very easy

thank you for you're helpful video 🙏

Leave me a comment if you found this video helpful

Puppy ? ;-) I'm pooped trying to get the Gland slackened on a Cat. - this is more like my old Masseys - but thanks for showing & NOTEd the on-screen Text ref filler ring. Haven't seen that supplied / done before. good to watch things right thru' - JUST to LEARN. Thankyou

Yep helps a-lot. I have 310G that the same cylinder is getting very hot and noisy like a dry pin that needs grease. Need to pull it apart and see if it is fix-able or not

I have the same set up on my 1966 ck case 530 188 Diesel Backhoe

Thats some great info. Had no idea how to do this. Is it very hard to pull the rod out ?

Many thanks for the video. I have a 1989 John Deere 410C and I'm in the process of repacking all of the cylinders at the moment. I already have all of the seal kits for both the pistons and the guides on each cylinder, however I'm taking all of them to a local business for them to repack for $70/each with the exception of the swing cylinders... It looks like the swing cylinders are easy enough to repack while mounted on the machine... Do you simply swing the boom all the way to each side when attempting to disassemble each cylinder? Also, did you end up also replacing or sleeving the pivot pins on the boom where the boom articulates right to left? Any information would be appreciated. Again, thank you for the video and great channel!

I've been beating and beating on the retaining collar. Seemed unlikely it would be stripped, after watching it's likely unscrewing I'm just pushing that collar in at the same time which is why I see no difference, I hope. now back to work.

For anyone watching, I cannot seem to get the glad to push back into the cylinder. Any suggestions? The retaining (snap) ring is froze and will not spin either

Es lo básico que debes saber de los cambios de cauchos de los vástagos

Could you use the boom to pull the rod out instead of a come a long? Hook a chain to the bucket and extend it. Don't hit the swing pedals of course ;-)

You mean 310 E right not a 350e ?

Risk

Hindi me video bnaiya

I have a problem with my 310G in the swing cylinder is very hot i use only 10 min for touch very hot i donot why?? Somebody help me