Replacing inner and outter tie rods on Honda Accord 2003 to 2012

Рет қаралды 13,400

Жыл бұрын

Due to factors beyond the control of RB The Mechanic, it cannot guarantee against unauthorized modifications of this information. RB The Mechanic assumes no liability for property damages or injury incurred as a result of any of the information contained in this video. RB The Mechanic recommends to follow safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, chemicals, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of RB The Mechanic, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not RB The Mechanic.
RB The Mechanic. All rights reserved. Publication, reproduction or distribution of this or any video by any means whatsoever, including without limitation electronic transmission via internet or e-mail, or re-uploading existing videos & re-uploading such material on any website anywhere in the world, is strictly prohibited without the prior written consent of RB The Mechanic.
#innertierod #hondatierods #outtertierods #hondainndertierods #howtoreplacetierods #toolsfortierods #2004accordinnertierod #2005accordinnertierod #2005accordinnertierod #2006accordinnertierod #2007accordinnertierod #hondaaccordinnertierodend #accordinnertierodreplacement #accordouttertierodreplacement #accordreplacementtierod #tierodends #outtertierodends #innertierodends #playintierod

Пікірлер: 33

@brentwoelk3491 6 ай бұрын

I like how you are straight to the point. I've watched alot of videos from other people that make you sit through 10 minutes of talk before they get to the point.

@RBTheMechanic 6 ай бұрын

Yeah I do simple to the point video

@ProJanitor Жыл бұрын

You make these jobs look a lot less intimidating 💪

@RBTheMechanic Жыл бұрын

Yup

@richardfabrizio8998 Жыл бұрын

That was a great job. Thank you

@RBTheMechanic Жыл бұрын

Thank you!

@jaimeramos2644 8 ай бұрын

Great video!

@RBTheMechanic 8 ай бұрын

Thank you

@JizzleCX 5 ай бұрын

If that tie rod goes bad again the next guy to change it is gonna curse your name. Blue loctite is fine. And use a torque wrench to tighten to spec. Otherwise good video

@RBTheMechanic 5 ай бұрын

I RED! All the way safe than sorry. And it comes with red locktite

@SomeWhereByMarzzz 10 ай бұрын

I could not get this jam but lose.

@Ballong101 Ай бұрын

How much is labor for replacing the inner and outer tire rod 2013 accord

@RBTheMechanic Ай бұрын

Usully I charge $140 each side both tie rods and I adjust them to best of my ability to keep tires straight till u get to alignment

@satriojumeneng7055 10 ай бұрын

Do we need to replace both the right and left sides?

@RBTheMechanic 10 ай бұрын

Yup both need to be done togather

@briantezo9232 9 ай бұрын

What's the average cost to replace them? I don't have that big tool to remove them so am a take it to the shop.

@RBTheMechanic 9 ай бұрын

Rash side both tie rods run around 340 parts and labor

@Cobra.7 Ай бұрын

Yo i got a 2013 accord how many spin to take off the outter rod

@RBTheMechanic Ай бұрын

There’s no such a thing how many spins u have to count to see where ur tie rods sits every car is diffrent

@caliman777 4 ай бұрын

Hey brother I have an 06 Accord V6 I replaced my tie rods maybe 2 years ago Amazon I'm able to move the outer tie rod side-by-side with a little strength it's not hard at all to move side to side is that normal it's not like a super loose or anything but I'm able to move it side to side with a little bit of force

@RBTheMechanic 4 ай бұрын

There shouldn’t be okay moving it from joint is fine but joint shouldn’t have play

@caliman777 4 ай бұрын

@@RBTheMechanic thanks brother I have clunking and creaking only when front driver side wheel almost underneath the pedal my lower control arm the front is cracked but not major my swing links look good the creaking and only happens when I drive when I try to jump up and down on the car there's no noise it only happens when I drive

@just4knives57 Күн бұрын

This a 2.4 or a 3.0

@RBTheMechanic Күн бұрын

2.4.

@bigt8699 9 ай бұрын

Do i need to grease the inner joint?

@RBTheMechanic 9 ай бұрын

U should to make it the best

@LuisCastillo-tw1ij 3 ай бұрын

Whre u get the tire rods?

@RBTheMechanic 3 ай бұрын

From my local part store buywise auto, you can also purchase it from autozone or pepeboys

@jonrambo9143 3 ай бұрын

Good video I just don't like how you tell people to count the threads not all out of tie rods are created equally use a tape measure always had better results I mean if it works for you it works for you but sometimes the thread depth is different and sometimes the tie rods aren't as long this only works at the exactly the same in a lot of cases they're not. Good video otherwise

@RBTheMechanic 3 ай бұрын

Oh ok yeah but it’s pretty close at least ur car will be stright to get to alignment place I seen sun mechanics do work and u can even drive