Will you deliver it to india

Didn't receive instructions or pouring cap.

During the desulfation process, the amount of sulfuric acid in solution will increase, or in other words that specific gravity will get larger. It may be a good idea to check the specific gravity(highly affected by H2SO4 in solution) of the electrolyte after using our product if you had to drain the electrolyte and possibly add Sulfuric Acid. However, this might not be necessary if you are seeing adequate results with your battery. Thank you for your question.

You ever fix it just did the same thing? Or do I just buy new batteries?

You ever fix it just did the same thing? Or do I just buy new batteries?

Was thinking the same thing

youre correct that the video doesn't show Amp Hours, but deep cycle batteries do ahve CCA measreuments/ratings. I dont know of a way to test AmpHours. Do you?

Thank you for your comment! Please hang tight as more content is made showing features like this.

Nobody said the battery was bad voltage but point was the cca’s were down from 700cca when new to then mid 400’s cca showing the battery lost current/cca’s. Post treatment with the product & a slow overnight charge the battery cca improved from mid 400’s to upper 600’s cca which is the point here. Now that same battery should last/perf better in the golf cart

Hello, that is a great question! Please send us a message through our site at homechemauthority.com/contact-us/ and we would by happy to help with your situation.

We are deeply sorry that our product did not meet your expectations. You can contact us through our website at homechemauthority.com/contact-us/ and we would be happy to help with an issues that you had.

Great Question! Although a trickle charge produces the best results, if you do not have access to one you can also use a regular charger. In this case however you will want to run two or more charge/discharge cycles in order to get similar results. If you have any more questions please do not hesitate to ask away.

Great Question! LiquidRegen is not designed to replace the original liquid found inside of your batteries to we do not recommend removing the liquid from your batteries. This may cause issues leading to unrepairable cells. Instead, we recommend follow the instructions that come with our LiquidRegen sets which explain the exact amount of Liquid to add (in ounces) based on the voltage of your batteries. If there is too much liquid in your batteries, we only recommend removing a small amount to allow our product to fit, and then using the same liquid you removed to top the battery off. If the fluid level is still not high enough in your batteries after, you can use distilled water to help submerge the cells.

Great question! Much like adding sulfuric acid, LiquidRegen increases the specific gravity of the battery; however, it also removes sulfation leading to better performance and longevity when compared to just the acid.

@@liquidregen great. So I have a couple of wet cell semi sealed AGM batteries that have dried out. 1 I think I boiled dry with too higher voltage and has no current capability. The other just deep discharged too many times. The latter still starts the vehicle as long as its kept charged, but has no useful capacity. Added demin to both and hold voltage but no improvement. Any hope for either?

@@WaynesWorld999 Unfortunately LiquidRegen is only designed to work with deep cycle lead-acid batteries. In your case it is unlikely it will work with the AGM batteries, especially the one that has dried out.

Yes! You can purchase it on our website at homechemauthority.com/product-category/household/golf_cart_products/

Do you ship in Canada? I need this. Thanks

Great Question! LiquidRegen is typically used to restore older batteries so if you plan to use it an a battery that is newer than one year I would recommend contacting us about your situation before using LiquidRegen. Preventative maintenance is extremely important so we would be happy to help. Contact us here, homechemauthority.com/contact-us/

Hello! That is very strange, but we would love to help. Please shoot us an email at Support@HomeChemAuthority.Com

I had the same issue. In order for the charger to initiate a charge it needs to see 30V (in my case I have a 48v cart 6batts 8v each). They all read 1-2 v. I used my standard car charger on 12v for about 3min on each battery, just to surface charge enough for the big charger to take. It worked. I did order more fluid for further maintenance.

Front-

Yes, we ship outside of the United States. For more information please contact us through our site at homechemauthority.com/contact-us/

Did you get a answer