Reuphostered Boat Seat Cushions

Рет қаралды 20,143

2 жыл бұрын

This was a project that I did with my son. He recently acquired a boat that was 25 years old and most of the cushions needed to be replaced. Using new marine vinyl, a new seat board and revitalizing the foam, we were able to reupholster several seat cushions for his boat. This project works best with two people, due to the pulling the vinyl snug and making sure the staple gun was in the right place. We were able to take the boat out on the lake, and not only were they sturdy, they were also very comfortable. This project was easy to do, and it was fairly inexpensive. I'm sure if you need to do a project like this, you will come off of it with great satisfaction.

Пікірлер: 10

@leonardojones4486 4 ай бұрын

For anyone doing this a piece of advice replace your boards and cover them in fiberglass resin that's mixed with 5% acetone so it's easier to work and take longer to cure because Thompson water seal only last one year fiberglass resin last about 15 years also don't forget your spray adhesive to tack your foam to your boards so it doesn't move around when you're trying to put on the new vinyl.

@jaddascraftcottage6335 4 ай бұрын

Thank you for your advice. It was very useful!

@justdoit8613 Жыл бұрын

Very nice work love it.

@jaddascraftcottage6335 Жыл бұрын

Thank you. Taking something old making it new again!

@goodtimeswithal 5 ай бұрын

thanks for the info

@jaddascraftcottage6335 5 ай бұрын

You are welcome! Hopefully you can reupholster your seats

@Spacesprocketz 7 ай бұрын

Thanks! I found a winter project for my Mom lol!

@jaddascraftcottage6335 7 ай бұрын

Thank you! I did this project with my son because it is his boat. Good luck!

@sherryodom2114 2 ай бұрын

How do I figure out yardage to cover my seat cushions and backs

@jaddascraftcottage6335 2 ай бұрын

Thank you for your comment! The marine vinyl I got was from JoAnn Fabrics and it was 54" wide. It can be pricy but you want to get a little more than you need. You should measure your cushion the width, length and height of cushion. For example the cushion is 30"x44"x6"... the width would 30" plus 12"(2x the height) = 42". the length would be 44" plus 12"= 56". That is the size of the cushion, now you need to add at least 3" all around for the tacking. The size is now 48" x 62". For that cushion because the vinyl is 54" wide, that will cover the width of the cushion but the length will need at least 1 3/4 yards of fabric. Again, I would probably get a little more just to make sure it fits. Good luck with this project.