The nut you keep on tightening has nothing to do with sealing when in use. It is intended to: 1) screw on a flexible membrane, to give you a sealed cap(in case you decide to store it or transport it for recycle); or... 2) unscrew and help disconnect the sealed hose from container at the end of the job(instead of pulling/damaging the connections)

The fact you can put the hose back into it after using it is worth buying it alone. I have two fluid vacuums and those create an absolute mess just from residual oil.

I wish that it had quarts marked out on the side. I had one of these from a different company that I got about 20 years ago where each rib on the container marked a quart. Haven't seen that feature since. Damn that was a cool one, wish it never broke.

These tools are the best for power steering flush. You just suck out what you can get from the Reservoir then put that much back in. Then start up the car and turn the wheel all the way left then right 10 times. Rinse and repeat until the fluid coming out looks like new. Usually takes about 3-5 time. Yes you waste some fluid but it's better than the alternative on most cars. Just remember to put two layers of cardboard under the front wheels or you'll have bad rubber marks on your driveway from the left right part.

Excellent video

Do you push the hose all the way to the bottom? It can bend and reach like that?

That extractor is pretty darn nifty. I can see that saving so much time on multiple fluid changes. I didn’t see but how much fluid does it hold? Great video.

Anyone ever use these to extract gas out of a motorcycle gas tank? Will it ruin it?

Im debating on getting this . Does it show your the measurements on the side(

Thank you for doing the video. I would like to know how many quarts oil pumped in how much time?

You should of put some food dye in the water.

Using this tool on a Honda outboard. Does removing the engine oil filler cap actually make it suck out faster?

How much psi did you use to extract the transmission fluid? And what size hose did you use to extract the fluid from that piping?

Subscribed!

Tried it brand new to remove oil. Didn’t work.

Thanks for this, I just got the 9.5 litre one . Question, can you unscrew the top to clean it. I tried a little bit, but I was afraid I would break it

How do you clean it out?? Also what PSIG was your compressor set at??

demonstrating equipment is not your calling. Really sad.

Dude, get a tripod, I'm getting sea sick