Bonny Doon Mini Coining Die Shot Plates

Рет қаралды 9,890

10 ай бұрын

Peter Gilroy from Bonny Doon creates small components using the mini coining die shot plates. He starts by making metal shot from wire and then uses the Monster bench block, a hand punch and 2-lb. brass mallet to get crisp details. Peter also demonstrates using the coining dies with your hydraulic press to get clean impressions. Finally, he walks you through polishing the die to keep it in like-new condition, delivering the results you count on.
Check out the products featured in this video:
• Bonny Doon Monster bench block: tinyurl.com/4fcet3bx
• Bonny Doon die shot plates: tinyurl.com/n3edcx9t
• Bonny Doon hydraulic presses: tinyurl.com/6nwhdmz6
Rio Grande stands for makers who create with their hands and their hearts and who are courageous enough to make jewelry their livelihood.
Connect with Rio Online:
Visit Rio's Website:
Subscribe to Our Channel: ow.ly/dAbu309U7eg
Find Rio on Facebook: ow.ly/DpRd309U63Z
Follow Rio on Twitter: ow.ly/wdtU309U6oF
Follow Rio on Instagram: ow.ly/eu5A309U6vM

Пікірлер: 12

@jjotero8025 10 ай бұрын

Great video. The instructions are great. The outtakes bring some personality. I'm looking forward to using my set.

@carlstanley9226 10 ай бұрын

Something I figured out years ago is to use a stationary planishing hammer (my students call it the Bammer) to hammer the shot into the plate. The guided and sprung hammer face goes down parallel to the heavy base so you cannot veer off at an angle and accidentally damage your plate. 2 or 3 strikes and you have great results all day long. Plus I put a little mineral oil in the plate impression for clean removal. You heard it here first! Carl Stanley from Carl Stanley Jewelry Arts - Santa Barbara, CA

@petergilroy9503 9 ай бұрын

That's a great tip! I don't have a "Bammer" but i might have to get one now! One thing to note, the way these dies and punches are precision hardened means that the punch is slightly softer than the die, so it would take some real effort to damage the die.

@Kera.S. 10 ай бұрын

The bloopers were so worth watching till the end! Love it 💙 TFS about the products too!

@consueloyoung4484 10 ай бұрын

Loved your video, very informative, thank you 🙏🏼 ❤

@farooqalikhan8400 8 ай бұрын

Thanks for teaching ❤

@duocmat5192 10 ай бұрын

❤👍👍👍

@1catfishuntermiller753 10 ай бұрын

Hiya guys, awesome video and you guys are so funny. But hey yall do better than I can do. Because I choke up everytime I try to make a video. That's why I haven't made one yet. 😂 I hope yall have a awesome blessed day. Cya! 😺🐟out!