How To Install The Tusk Motorcycle or ATV Seat Heater

No video

How To Install The Tusk Motorcycle or ATV Seat Heater

Рет қаралды 40,287

Күн бұрын

The Tusk ATV/Motorcycle Seat Heater is the ideal accessory to add to your machine when riding in cold weather conditions. The seat heater panel fits under your seat cover and connects to your battery for easy installation. This heater includes a switch with High and Low heat settings to make it easy to set your comfort level. It would be a great addition to your motorcycle for dual sport and adventure rides, as well as cold weather rides and plowing snow with your ATV. Works on most motorcycle and ATV applications.
Shop Now | Tusk ATV/Motorcycle Seat Heater
www.rockymount...
Watch Next:
Tusk Heated Grips Kit - Installation
• Tusk Heated Grips Kit ...
How To Install Grip Heaters - For ATV's, Motorcycles
• How To Install Grip He...
Click Here To Subscribe To Our Channel!
/ @rmatvmc
Follow Us On Social Media!
FACEBOOK: www.facebook.c...
INSTAGRAM: www.instagram....
TWITTER: RM...

Пікірлер: 35

@Storm-rp9xe Жыл бұрын

Just installed mine yesterday works like a champ, definitely hot in the high setting which is fine here in the Pacific Northwest

@gregoryaparker 3 жыл бұрын

I'm going to do this next week except I'm going to have mine connected to the ignition so I don't have to worry about leaving it on in the winter while I go to work. I don't want to come back to a dead battery.

@SontaiWatson 2 жыл бұрын

doing the same thing right now

@waterfordMARTIN Жыл бұрын

Same here..straight to baterry is just a bit dangerous 😉

@BerryTheBnnuy 4 жыл бұрын

I have a Kawasaki Police 1000. The stator in that thing produces ~20 amps at idle. I think I'll be good.

@TheEasyrider1200 Жыл бұрын

Can the heater sit on a seat gel insert, and can you cover it with 1/4 inch finishing foam to make the install look better?

@theRealFaceCap1 10 ай бұрын

Good question, that's what I'm looking to find out!

@aimlesstony9017 3 жыл бұрын

So if it gets wet is that ok?

@johnnelson8271 4 жыл бұрын

will this be ok on a 2018 Can-am spyder rt limited?

@ktproject5070 2 жыл бұрын

The switch has high and low but does it have an “off” setting?

@rmatvmc 2 жыл бұрын

Yes, the middle position is the off setting.

@checker3694 5 жыл бұрын

Looks great, but would like to see pad fitted afterwards, does it show on the through on seat base,I suspect it does, or you would have shown it afterwards

@checker3694 3 жыл бұрын

Yes it does, he tries not to show it, that's why I tuned in, it's got to be invisible once cover goes back on, otherwise its a half ass job

@dorotheacrowley196 2 жыл бұрын

What size drill bit is being used?

@thatoneguy2756 5 жыл бұрын

Rocky Mountain ATV MC , where is the resistor in the harness on this setup? I am gonna eliminate the relay as I am gonna wire it into a fz-1 fuzeblock with a relay already in it.

@michaelsandgren1328 4 жыл бұрын

Do you sell any smaller ones? I'm guessing i can't just cut or two fold it? Want to install one on my old slingshot, but the saddle is way shorter than 40cm. Great video by the way :)

@rmatvmc 4 жыл бұрын

The ATV/Motorcycle seat heater is the smallest one we carry but you are able to fold it if needed for your installation. Hope that helps!

@adamthompson8432 2 жыл бұрын

I did see a guy cut one to fit his but it might have been a different video. I’ll see if I can find the video but I would just fold it like RMAM said above.

@adamthompson8432 2 жыл бұрын

kzfaq.info/get/bejne/gM-EdLxnsb_WdZc.html

@SamIIs 5 жыл бұрын

I like the idea of going through the seat for a cleaner look, but drilling a hole through the foam to accommodate the electrical connector just doesn't seem to sit well. Would it be better to cut the connector off, push a hot wire through the set cushion for a much smaller hole, fill the hole with silicone; also apply to the wire harness, run the wire through the small cushion hole while the silicone is still wet and then re-pin the connector on the bottom of the seat. This is just to avoided compromising the seat cushion because the seat cushion can be real touchy, sometimes they last sometimes they dry-rot once dry-rot sets in its all down hill from there. "Just sayin' "

@garrettalward5727 6 жыл бұрын

Can you addd this to a bike without a battery

@rmatvmc 6 жыл бұрын

No, you would need to have some sort of battery source.

@danmanthe9335 6 жыл бұрын

Garrett Alward that'd be sweet if you could though!

@shep236 3 жыл бұрын

I don't see why you couldn't cut the red wire and wire it to a power source while the bike is running, the relay supplies the power not the battery. Having it wired to the battery means its hot at all times so you have to make sure your seat is off or you'll drain your battery down. Not the best design at all

@2wheels1guy25 Жыл бұрын

@@rmatvmc why, you can just wire it up to the alternator and the chassis right? 20watts is almost nothing. Maybe add a time delayed relais (10sec) to prevent kicking it till your boot is penetrated by the kickstarter.

@user97877 2 жыл бұрын

Hi nice video, i have 2 quetions about the producct is it compatible with a BMW G 310 GS and second is it worth buying in cold weather for example ( 0 celcium) ?

@rmatvmc 2 жыл бұрын

This Tusk Seat Heater will work with your bike and is a great accessory for riding in cold weather.