Como è q se faz para indereitar a mesa desta maquina?
@Corné-o6h Жыл бұрын
If you want to get to a certain thickness you need to do it in steps. Otherwise it is too much for the engine to cope with. Not so much the blades, but it gets so much material to cut, it takes too much force. And then a fuse blows, if you're lucky ;)
@Corné-o6h Жыл бұрын
Also when planing an edge, adjust the backup so that there's only a small edge of the knives visible. As much as you need, so your lose hanging shirt doesn't get caught in it when you don't have to bend so far over! Omg, get some instructions, before you hurt yourself.
@user-jo8ol1ce8r6 ай бұрын
Gostaria d saber como a serra desta maquina d aparelhar funciona
@elinys2843 Жыл бұрын
Please use the safety devices that come with it. That horizontal drilling head will grab you sooner or later.
@blackdragon8605 Жыл бұрын
¿Por qué el riel del trineo está montado así? Lo monté dejándolo salir por completo hacia atrás, no hacia adelante. Corté mejor los paneles...
@killmanjarto2 жыл бұрын
Te recomiendo que no acerques tu mano así nunca a una tupí. Muchos carpinteros experimentados han perdido dedos...
@carpinteriaepoxy23522 жыл бұрын
Gracias por la recomendación amigo si trato de ser muy precavido pero aveces se le van las cabras a uno . En que minuto hiciste esa observación para revisar el video?
@user-jo8ol1ce8r6 ай бұрын
Como è q se faz para indereitar a mesa desta maquina?