Robot Vacuum Repair

Рет қаралды 35,650

2 жыл бұрын

A few things you can do to fix your robot vacuum. Mine ended up needing a battery, and they are easy to replace. This is a Proscenic M7 Pro, but this video applies to most robot vacs.
Battery: www.amazon.com/dp/B089SRMBBH

Пікірлер: 26

@mcascone Жыл бұрын

This is the only video i found that matches my Coredy L900. Thanks!

@zorraidaperez8891 Жыл бұрын

I watched your video and I am going to try changing the battery, thank you for the content and the link for the battery!

@RedChord7 Ай бұрын

Just what I was looking for 😊

@shafter1118 2 жыл бұрын

Thank You! You are a lifesaver.

@silnati 9 ай бұрын

Thank your for posting this video! Our IRobot suddenly stopped working this morning and I was already using the broom ro clean de messy floor my toddler is in charge of and....came cross your video, luckily our case was just a deep clean needed !!!! 🎉🎉🎉 anyhow know I also know about the battery.

@RecentlyAdded1 2 жыл бұрын

Nice video Lou. Short and to the point. Don't you think that 15 months is kind of a short service life for that battery?

@HowToLou 2 жыл бұрын

Lithium batteries typically lose capacity pretty drastically after about 500 charges. 15 months is 450 charges, so not too far off. The new battery was only $20

@QreatorXD 7 ай бұрын

Why does mine not mop the floor

@Highlander1518 8 ай бұрын

I bought a Lubluelu SL60D robot vacuum back in March 2023. It’s been running fine until last week. The app says the battery is at 100% but when I send a command to the robot it just completely cuts out once it’s left the charging base. Then weirdly, if I put the robot back on charge it doesn’t seem to go past 30% charge, even after leaving it all night to fully charge. A hard reset didnt resolve the issue. Do you think it needs a new battery?

@mdc4454 2 ай бұрын

HI thank you for the video. I had the same issue I have changed the battery. Unfortunately the issue is still persisting. I have checked that the connector and it works. I have checked the voltage that arrives to the battery is 2.6 I am not sure that it is what it should be. The light is still flashing red and violet. I disconnected the battery but still the same. Any advice?

@answernotfound5278 2 жыл бұрын

Have had many robot vacs, neatos (yes plural) roombas, and a shark iq. All except the new shark robot have had multiple battery replacements. The robot may be top quality, but the batteries they choose to put in are super cheep.

@HowToLou 2 жыл бұрын

Agreed. They give you just enough to get past the warranty 😬

@answernotfound5278 2 жыл бұрын

@@HowToLou yep.

@RCAtomicfr 16 күн бұрын

Hello, what is the voltage on the white wire?

@mike97525 2 жыл бұрын

You could probably get that battery from a rc hobby shop

@xytras Жыл бұрын

It worked whe the batt is full. but when docking to charge, it won't charge. is it because the original battery came with 3 wires?

@HowToLou Жыл бұрын

No, the two wire battery works fine. You may have an issue with your charging station

@TheReelport 5 ай бұрын

I have a similar issue, the new battery has a different wiring (-) and (+) or red/black then the original battery and I have two other wires open end, what are they used for? Robot not working though, wrong wiring showed 1% new wiring according to the poles shows 60% but it turns off the moment it leaves the dock...

@caitlinevans9757 4 ай бұрын

I have a trifo hover and I can't get hold of the seller or any help or support. It's just stopped working and I cannot get it back on. Does anyone have any advice please 🙏