Ryobi Pressure Washer Leaking Oil

No video

Ryobi Pressure Washer Leaking Oil

Рет қаралды 7,669

PNW Small Engine and Lawn

Күн бұрын

This video is about Ryobi Pressure Washer Leaking Oil

Пікірлер: 19

@mister-action1 Жыл бұрын

I went through a lot of drill bits. Man, that's a hard metal bolt!!

@jerrysoutherland662 Жыл бұрын

Another great video,I always had some trouble getting the valve cover off,wish Honda made a valve cover gasket.

@PNWSmallEngineandLawn Жыл бұрын

Ya it's very annoying. All the other Honda do

@spettro9 10 ай бұрын

I just took my friends to start it/clean carb, and it was leaking a good bit of oil. It's actually the oil seal at bottom of engine, for sure.

@PNWSmallEngineandLawn 10 ай бұрын

I don't usually see hondas with that problem but it can happen. If you need any assistance with the replacement let me know. pnw.smallengineandlawn@gmail.com

@haroldrice7782 Ай бұрын

What kind of platform are you using to elevate your pressure washer?

@PNWSmallEngineandLawn Ай бұрын

I think it is a vevor lift table I added a top to make it wider

@Pingaheimer 4 ай бұрын

Did it leak after this? For me it wasn't the seal on the cover, it was an o-ring on the camshaft. Luckily i had an old o-ring kit from Harbor Freight with an exact replacement for it.

@PNWSmallEngineandLawn 4 ай бұрын

It stopped this leak. The crank seal can also be the problem but valve cover leaks are something I see often

@mister-action1 Жыл бұрын

Have you had any Kohler 7000 24 Hp. bolts sher off of the crank? That turns the mower belt. I took the motor off the frame and tried to tap the bolt. My tap broke off. I drilled a hole next to the tap and finally got the tap out. Is it hard to replace the crank? Or should I try to re thread the crank? Does the bolt have thread lock on it?? Thanks for any help.

@PNWSmallEngineandLawn Жыл бұрын

It isn't hard to replace the crank. It is very expensive considering you will need a new crank and gasket kit. Personally I would rethread the crank.

@mister-action1 Жыл бұрын

@@PNWSmallEngineandLawn I'm going to give it a try. The hole is to one side of the broken bolt. Is that very common?

@markrodgers1965 Жыл бұрын

Great video What is the torque spec ?

@PNWSmallEngineandLawn Жыл бұрын

Roughly 7 ft pound

@mister-action1 Жыл бұрын

I just wanted to comment.

@pepetravel74 Жыл бұрын

Hello , my is leaking oil through the filter…any idea what it is happening

@PNWSmallEngineandLawn Жыл бұрын

I would think your oil is over filled or your carb is leaking gas and going into your engine and mixing with the oil. After a while it will start coming out of the carb. Smell your oil. If it smells like gas then repair the carb and drain the oil