In this video you see how I install a simple switch to separate the 2 batterys on Melissas RZR
Пікірлер: 23
@hillbillyhangover2 жыл бұрын
Thanks for the vid!!! I like it!!!
@jandelahoussaye98344 ай бұрын
Why not put a car battery?
@ceg09152 жыл бұрын
Got my first razor 1000 recently also. Noticed that under the seat the battery and some wired/fuses are exposed. (No cover) is that how most razors are? Just thinking if it'll have electrical issues when it comes to washing the dirt that's under the seat
@adamepperson40412 жыл бұрын
No that's not normal it should have a cover that snaps on over the factory fuse box
@ceg09152 жыл бұрын
@@adamepperson4041 hmmm I'll see about buying a cover. But no cover that covers that whole tray where battery and fuses are located?
@adamepperson40412 жыл бұрын
No cover for batteries and everything, only the factory fuses. If it has single wires running off the positive side if the battery with a fuse on the wire, that would be a fusable link and some of those dont have covers either. Your factory fuse cover will have what each fuse is and location on it as well.
@danielaguirre61273 жыл бұрын
What type of battery is the second one? Does it need to be deep cycle AGM? Or can it be any 12v battery?
@adamepperson40413 жыл бұрын
My second (jump battery) is just a Walmart 325CC lawnmower battery. I had to cut the plastic between the 2 battery's to get it to sit flat. I got a pair of cutters and cut it in a few different places then got a pair of channel lock plyers and tore the pieces out.
@marcoperez89703 жыл бұрын
So you only flip switch when battery dies??
@adamepperson40413 жыл бұрын
Correct. Open switch to when sitting close switch to start and go. Simple as that.
@marcoperez89703 жыл бұрын
Thank you for your response i just did the same setup
@adamepperson40413 жыл бұрын
Good deal.. hope it works as good for you as it has for me.
@sportbike2222 жыл бұрын
Ok help plz I found the same switch at napa but only one of the holes is threaded and ones just a hole so which battery goes to the threaded hole and of course the other battery well go to the none threaded hole thxs.trying to set mine up the same way thxs
@adamepperson40412 жыл бұрын
Hey Sean, sorry for the delay, I used a bolt with a lock nut to hold it on.
@EJfromNYC2 жыл бұрын
You can find the other one on Amazon for 15 bucks.
@brianmabe302 жыл бұрын
Do you have switches on the accessories or they always on?
@sportbike2222 жыл бұрын
Is it just a single pole throw? And you just run both negative wires from both batteries too it correct? This throw switch I have has a red and black does it matter which one goes where on the switch?
@adamepperson40412 жыл бұрын
I would use the negative, due to spark. It doesn't, but if it did you rather it spark to a ground.
@EJfromNYC2 жыл бұрын
What battery brand do you guys use as the 2nd?
@EJfromNYC2 жыл бұрын
Man this is so simple... No extra components... Sometimes simple is better, until you get drunk and forget to flip the switch 😂
@nachitosounds12233 жыл бұрын
you have no problem with the voltage regulator if it can charge the 2 batteries