On my 55 shorthood installed a oil catch and a PCV. This setup helps on warm up and the oil leak from vent tube. Also surprised the water is taken out of the air. Used 1/4" mini air filter # 68225 from Harbor Freight and PCV1181DL from Autozone. Solder a brass 3/8 barb fitting from vent tube, then 3/8 hose to filter, 1/2" barb fitting and 1/2" hose to PCV. Next 3/8" barb fitting to intake. You have to adjust low and high idle.
@DavidFinchMMC9 жыл бұрын
I thought the whole reason for putting a roof on that was to not have snow on there 😈. Looking good, I was thinking 4 pulls myself, guess I shouldn't buy a lotto ticket this week.
@Nyoest9 жыл бұрын
Well most of the pulls are just to get the piston on TDC to crank. :)
@jacobjones94613 жыл бұрын
That thing is a dinosaur.
@johndunn98195 жыл бұрын
good iron. good iron.
@itssavage69967 жыл бұрын
do those weld good? was looking at one and didnt know much about them
@Nyoest17 жыл бұрын
itSSavage 69 they weld the best as far as I'm concerned
@mikecubes16427 жыл бұрын
nothing welds better than a short hood lincoln not even new machines can come close.