In acest video voi monta senzori de parcare pe un Opel Corsa D. Sensorii sunt model PNI P03
Пікірлер: 14
@dragosturcu99593 жыл бұрын
Aveai semnele pentru senzori pe spatele barii. Se vede in video ca ai facut gaura pe langa ele.
@TheFrankonia833 жыл бұрын
Hi there, which cables are + / ground?
@LiviuDDL2 жыл бұрын
Salut care este firul de masalier , din tripla ?
@schatzi19554 жыл бұрын
wenn du die Stossstange abbaust, musst du nicht von aussen messen. Da sind Markierungen von innen (fast an den Stellen, wo du gebohrt hast)
@SALProjects4 жыл бұрын
Ich sah, aber nach der Montage :)
@schatzi19554 жыл бұрын
@@SALProjects aber da du ja auf youtube bist, hätte ich mal geschaut. Ich habe meinen Corsa D seit 4 Jahren, wollte auch so etwas montieren, habe aber eine Kamera reingemacht. Und ich habe auf youtube gesehen, dass die Bohrungen schon eingepresst sind von innen.
@andredx9589 Жыл бұрын
hello friend, could you provide me with the measurements where to make the holes to put the sensors? thank you
@DjRaz20104 ай бұрын
24mm
@sureshparmar82842 жыл бұрын
Is it possible to install them without removing the bumper?
@alyasrazzaq60852 жыл бұрын
Yes. Just feed through the holes you make and through the grommet in the trunk. That said, if you do go to the trouble of removing the bumper, why not save yourself the trouble of measuring up as well as the masking tape, by using the clearly marked circles on the inside of the bumper. Drill a pilot hole from the inside and the rest of the hole from the outside.
@sureshparmar82842 жыл бұрын
@@alyasrazzaq6085 Thank you for your reply. Because of the marked circles you mention, I will remove the bumper using this video kzfaq.info/get/bejne/rbiAmMZ_qrGXXZs.html. Thks again 😊.
@muratermis16983 жыл бұрын
En önemli olan kabloları ön tarafa nasıl geçireceğini anlatmamışsın👎
@florincl13 жыл бұрын
la opel corsa d din 2007 la becul de mansalier ai 6 volti
@SALProjects3 жыл бұрын
Se poate pun un releu actionat in 5V iar pe contactul acestuia sa pui 12v