Scissors: The Top 5 Reviewed

Рет қаралды 7,510

Sam's Upholstery

Күн бұрын

Пікірлер: 17

@kyleadams6170 Жыл бұрын

Kai 7250 all day

@StephenMcGregor1986 3 ай бұрын

Kai 7xxx series is the best, there is no discussion to be had Fiskars is junk, coatings come off easily, not very sharp, blades dull quick, had a pair just snap after using them to cut some cardboard, absolute horse manure products

@galaxytrio 2 ай бұрын

I like the floating scissors.

@javiermontes905 7 ай бұрын

Thanks

@wheelstandr Жыл бұрын

What got me on this video was an add for 9' Guggenhein IX Professional Tailor Shears. The only videos seem like a bunch of lady KZfaqrs that got a free set to review. That may not be the case but the only comparo was to a set of well used FISKARS.

@kite9039 2 ай бұрын

I think the part at the back is to glad along the table and not for pinky.

@zman8340 Жыл бұрын

Great video

@rest-today 5 ай бұрын

Nice review. Thank you. What do think of Guggenhein IX Professional Tailor Shears, 9". Am considering them. But, I'm a bit hesitant since they are unknown to me. Plan to use them to cut upholstery vinyl, cloth and batting.

@ryanaasheim5965 Жыл бұрын

I live a few miles down the road and would love to get one of your interiors in my old suburban some day!

@samsupholstery8499 Жыл бұрын

That would be cool!

@Solar_King 3 ай бұрын

last shears is a high quality professional Tailor shears, surely its gonna be expensive 😅

@RRaucina 10 ай бұрын

Inherited tons of USA Wiss shears from pinking to huge shears from my tailoring family starting about 1912. Still in perfect order. Too bad the new ones come from Columbia.

@meowzic 3 ай бұрын

Are Guggenhein good?

@wheelstandr Жыл бұрын

Where is your shop? Great job on the video.

@christianpatton142 Жыл бұрын

If ya bent one handle a bit on the Wiss they should close better. So is the sharpen-ability issue about the plating? Cause ive noticed certain scissors (some quite expensive ones) go incredibly rusty incredibly quickly if you rub the plating off in spots.

@StephenMcGregor1986 3 ай бұрын

Simple metallurgy... unless the blades are made from something like MagnaCut or CPM-20V, then they will oxidise Sharpness, edge retention, toughness, ease of sharpening, corrosion resistance are all factors to take into consideration