SEAFLO 56A Bypass Valve Adjustment to prevent cycling

No video

SEAFLO 56A Bypass Valve Adjustment to prevent cycling

Рет қаралды 11,713

MarineNow

Күн бұрын

Available here:
12V:
www.amazon.com...
24V:
www.amazon.com...

Пікірлер: 16

@neilnevis5636 7 ай бұрын

Thank you Sir. My Seaflo 55 is brand new and wouldn't shut off . With your advice a half turn clockwise did the trick. It shuts off now 👌

@Portugeezaa Ай бұрын

Just wanted to say thank you!! This video was instrumental to me sorting my seaflo series 42 pump out and being able to have a shower again! 😂

@miztrusa Жыл бұрын

Jus got the 42 series and it did have the cycling issue at low flow and doing exactly what you said to do in this video got mine dialed in to perfection. TY for the video 😊

@throughtheeyesofourtribe 5 ай бұрын

Any advice if the pump cuts off at full flow after 15-20 seconds?

@manfrednemeczek4108 Жыл бұрын

My Seaflo 55 twitches when off. Every 30-60 seconds it does this. I have confirmed no leaks in the system by isolating the pump. It still does it. Do you have a solution for this problem? Thank you in advance

@miztrusa Жыл бұрын

Bypass is over adjusted like he said.

@DocHoliday-to6kp 7 ай бұрын

The one way check valve that allows flow out of pump but not back through it may be dirty or defective.

@Dustin.G 8 ай бұрын

How much current does this pull? (Does it pull anything when its off?)

@markc8207 10 ай бұрын

I have a standard kitchen faucet and I cannot dial mine in. Is it possible that it doesn't work because of the aerator in the faucet?

@jzkbbi1 2 ай бұрын

If you have trouble dialing it in, error on the side of a little cycling.

@roroalv 9 ай бұрын

If using with a 1.2 gpm pressure washer, would this help ?

@roroalv 9 ай бұрын

I have the 33series

@jzkbbi1 9 ай бұрын

@@roroalv How is the 33 working out with the pressure washer?

@roroalv 9 ай бұрын

@@jzkbbi1 it does what it needs to do. Performs great however since they’re is very low flow, it shuts on and off constantly when running the pressure washer. No problems however

@jzkbbi1 9 ай бұрын

@@roroalv Perhaps try the 55 pump then. It may be that the variable nature of the 56A is lost on your application. Further, if the 55 still doesn't provide enough flow, you can plumb 2 in parallel to increase flow.