no i don't i've found the problem and i've fix the mainboard by replacing a burned resistor
@hichamrais50294 жыл бұрын
@@EvrosNeofytides Hello sir, please I would like a help if it's possible, I'v got the same problem in my paper cutter 4660, the blade cuts but when I try to push rest it gives me this problem E--2 Fault Press Motor/UL, Knowing that the main board is new ( new paper cutter). Thanks for giving me anything that may help.
@EvrosNeofytides4 жыл бұрын
@@hichamrais5029 hi for me it was a small resistor that needed to be replaced in the area where the motor is connected
@hichamrais50294 жыл бұрын
@@EvrosNeofytides it was a resistor in the motherboard? I'm wondering if I should do the same, since my paper cutter is new, it has never served! And please sir, when you got this problem, the blad cuts like in my case or no?
@EvrosNeofytides4 жыл бұрын
@@hichamrais5029 My cutter was brand new so is better if you go to an electronic technician and tell him to check the resistors on the press motor output. The section of the press motor is where the press motor cable goes. This is as far i can help you!