Rebuilding my beat to crap aluminum boat. Added some rigidity to the frame, put a tunnel in the hull, and raised the transom.
Пікірлер: 16
@tnoel3743 жыл бұрын
Nice boat for the intercostal water way. Good work fixing everything.
@brendanbreen40994 жыл бұрын
Love the video and the details. Thanks for sharing your build and the customizations.
@foghole94492 жыл бұрын
Have the same size boat with a factory tunnel, 3" or so never really measured it. Mines not vented but you can feel the arse end lift up, when it really gets on plane. Only have a 30hp 2 stroke, get around 27 28 mph by myself, 13" prop.
@fabricobblegarage9545 Жыл бұрын
I didn't really think my vent design through, the way it enters the tunnel doesn't allow water to drop out. I should have made the little pocket span the width of the tunnel. Would have created more vacuum drawing more air, and distributed it more evenly. The way it is now i just get a little 2" wide pocket of air, but even so when you open the valve you can feel the boat lift up and get a bit looser.
@sharonbraselton4302 Жыл бұрын
12 foot skiff 3 inches too ppaning 1.5 iñcherh of water
@mikeverley6882 жыл бұрын
I am interested in building one myself. I was wondering what do you think about it and how did you come up the the dimensions for the tunnel?
@fabricobblegarage95452 жыл бұрын
There’s a formula for jet tunnels on outboardjets.com prop tunnels are a little different
@gmeister032 жыл бұрын
Still got this boat? Looks good. Why not run a jet?