How To Use a Router Bushing for Template Cutting

Рет қаралды 9,938

4 ай бұрын

We show you how to use a router bushing for template cutting and cutting multiple repetitive cuts. These brass bushings can be installed on your cordless router or corded router. Based on the offset of the specific bushing used determines how much larger the template needs to be. We used an upcut router bit to plunge-cut into the wood and extract the dust toward the top. #woodworking #router #tools
Brass Bushings Kit for Router: amzn.to/3wpccmO
Upcut Router Bit: amzn.to/3T3s1Zl
Keep current with our great content:
KZfaq: / shoptoolreviews
Instagram: / shoptoolreviews
TikTok: / shoptoolreviews
Facebook: / shoptoolreviews
Twitter: / shoptoolreviews

Пікірлер: 11

@mattedwards4533 Ай бұрын

I am retired but still retain my shop. I would not let my router bits touch plywood. Plywood will dull them fast. I also wish I had seem this video fifty years ago. I have wasted a lot of time centering bits and now you show me how simple it is with the coned gauge? Live and learn! Enjoyed the video.

@scotts4125 4 ай бұрын

I went through this about 6 months ago. I had to cut panels out of MDF doors to add louvers. I also used an upcut bit with a plunge router. I made a template out of plywood. I measured so many times to get this perfect. It was close but not perfect. I guess luckily it was a tad small so I trimmed the cutouts with a jigsaw. In the end it came out really well but I never could figure out why my numbers were off. I did add for the bushing and bit size. I also bought a centering tool. If I remember correctly you are suppose to only go one way (push) with the router too.

@MrDandaman137 2 ай бұрын

Try to avoid climb cutting if you can, it'll work better for you.

@strangetamer69x12 4 ай бұрын

Lowe’s actually has a metal bushing set made by milescraft. It’s not made of brass, which is really nice, but it’s durable enough to hold up for hobby use. I have the milescraft bushing guides & they’ve worked just fine for me

@pmcallister 2 ай бұрын

The offset is 1/16” if you use a 3/8” bushing and a 1/4” bit. And you are moving the router in the wrong direction in parts of the video.

@wooddogg8 2 ай бұрын

Counter clockwise in an inside cut like this? I think

@wooddogg8 2 ай бұрын

Actually I think I got that backwards. Clockwise for interior cuts, counter clockwise for exterior, like edge trim. left to right. Right?

@WalterBarger-io9ck 4 ай бұрын

Any good recommendations for a full set of router bits that are not going to break the bank has great quality will last quite awhile . Thank you for the awesome videos that you put up for everyone

@CMU295 Ай бұрын

Do you need a center pin cone for every base plate

@24savagelifeent.59 4 ай бұрын

Good Evening New to Your Channel sofar Love Its here well straight to the Point Can You Review DeWalts New Car/Truck Jump Starter DeWalt DXAELJ16 1600 Peak Amp Jump Starter Battery Booster with USB Power Station I have searched all over KZfaq sofar No one has a actual Review... Thanks Again!

@Dazza19746 Ай бұрын

You need to learn to use a router before teaching, and before losing fingers! ALWAYS go against the rotation, same as you do with a saw blade or anything else. There are times to ‘climb ‘ cut, but not by ignorance. 🙏