FAST hopup assembly

Рет қаралды 26,078

Silverback Airsoft

7 жыл бұрын

Installation of the FAST Hop Up unit for SRS airsoft replica

Пікірлер: 21

@shirkhan3818 7 жыл бұрын

The music on all your KZfaq videos is SO awesome !!!

@thebeni5452 5 жыл бұрын

I was thinking nice track choice too

@madmaxzwo 5 жыл бұрын

At 0:10 you put on one O-Ring then on 0:16 you point at the other and put it away. In the video for the carbon barrel you put on both rings. But how many should I put on or what's the 2nd O-Ring for?

@user-yr1xo1qt7j 6 жыл бұрын

good afternoon. Tell me how many rings should I put? I put two and very hard to scroll the regulator

@thedane9555 5 жыл бұрын

What kind of spring is stock on the silverback srs gen 3 a1 22inch poull bolt system 2018 Testing from the company just give fps with 0.20 and the test says 380 fps it must be under or Max a m140 spring right?

@AcidNightx 6 жыл бұрын

There is not a little tutorial to make it 100% airtight? xD and I had to add a teflon trick between the block and the graduated ring because after 30 balls I draw 1 ... (make it harder to turn) I'm going to test this weekend

@papenbajar9990 5 жыл бұрын

Do i need to set the rotating knob to 0 before screwing it in? Or does it matter?

@williamnohath 4 жыл бұрын

how do you know the fine adjustmen of bucking?

@dant3330 5 жыл бұрын

Awesome chamber, smart move from you guys! But for me it has a great fail... I miss some kind of "centering/locking" clip to the inner barrel to get rid of those screws that can loosen with vibration, and make installation a little bit easier. Like in the Maxx Pro chamber for M4, or Action Army chamber for Well L96... etc. With your engineering skills I'm sure that it would'nt be so hard to make. Keep up the good work!

@Khunez 5 жыл бұрын

grub screw is 100% secured vs the clip. also use some blue loctite for your loosening problems. The stock hop had loctite on its screws when i took it apart.

@dant3330 4 жыл бұрын

@@Khunez Thanks for the tip! I've mounted 10-15 different hop up chambers in all kinds of replicas. Never had problems with clips. Can't say the same with the screws... of course you can glue them but my pont is that a clip saves you the effort, plus if you're that kind of person (like me) who's constantly trying new buckings, inner barrels etc... things can get messy. I finally ordered a TNT chamber and a TNT S+ inner barrel. The chamber has 4 screw holes (Up, down, left, right), uses a VSR bucking with a R-hop type seam from TNT (included). Through the hole below, you can see the rail of the inner barrel, and this helps you in the centering issue. Plus the 100% airseal... perfect. Best chamber in every way. Cheers mate!

@christiandalessandro9612 Жыл бұрын

I mounted the fast hop up on my srs. Is there a way to see when it's perfectly straight? Because once mounted my BB curves to the left. Thank you

@cariocasniper5718 3 жыл бұрын

Um dos dois orings que fica dentro do hop dela saiu vindo a travar o meg ! Vcs já tiveram este problema ? Após isso tem horas q ela não atira vindo a travar