HI were i can found the adapder from OBD to wires? (the box with the 3 switches...) or even did you have pinout from kess connector? Regards Matteo
@miguelr8654 жыл бұрын
you use 470ohm or 560? In fgtech did 560 but kess did 470.. thanks
@obd9556 жыл бұрын
HI ANY PROBLEMS AND QUESTIONS I'M HAPPY TO HELP YOU ... THANKS
@khellilhichem12695 жыл бұрын
Kess original
@markc86713 жыл бұрын
Hi OBD, are you able to tell me what the Dongle is called with the 3 Switches and where can I get hold of one? Many thanks mark
@RaPiD000PRoZz4 жыл бұрын
What is that obd switch you have called please?
@siwypfk14 жыл бұрын
Did you solder resistors? or just connected to end of the test probes ? as long wire has resistance too
@Surfo19804 жыл бұрын
Looking for this answer too, since with resistors I can´t read it.
@loictorrent14825 жыл бұрын
Hi it must a resistance to make this?
@TechLabOfTruth5 жыл бұрын
where can i get this frame with testpins?
@edisonangeloalmazanbangug91754 жыл бұрын
Every time your gonna do bdm or jtag, does it need 12v power supply? I though the ktag (tuner) will power up the ecu? Just ordered ktag, kess, and fgtech v54 and BDM full aluminum frame. still waiting for it. What should i provide to buy next besides laptops?
@edisonangeloalmazanbangug91754 жыл бұрын
Have no yet experience in tuning. What are the toold needs to consider in order to do BDM tuning?
@edisonangeloalmazanbangug91754 жыл бұрын
It's my fist time whenever
@mikkifreeky4 жыл бұрын
How can i check lock/unlock status of simos ecu, ecu is on bench, so, no obd connection on vehicle is possible? my idea is to first connect ecu with bench obd cable with kess and make ID, i´am right? many thanks
@vintopin6 ай бұрын
It is also possible to immo off this ECU in Flash without emulator :)
@abdurrahmanozgezer5033 жыл бұрын
3 key apparatus written Hello cts. I need this too, can you write your model for me
@markc86713 жыл бұрын
Hi Mate. Dont know if you got my last message, but although I have KESS & Ktag, i dont have that lead with the 3 Switches on, was wondering what that lead is called and whether you know where I can get one, however, in my kit I do have a similar device that has a Toggle switch on it which I can email a picture to you and was wondering and perhaps hoping that the device I have will do the trick
@thebigsee15472 жыл бұрын
Just unlock it with ktag...that lead is just a homemade adapter...can h & L and OBD GND and +12v connected,thats all you need.The switches just switch power to pins 87? and 92?