Рет қаралды 31,985
@Radal 05
This video only proves the specifications of the tp4056 lithium lithium charger module
0:10 TP4056 Lithium charger
0:48 Function TP4056
2:33 Datasheet DW01A
3:58 Schematic of TP4056
4:20 Mosfet data sheet 8205A
4:53 Assembly TP4056
5:18 Maximum current charger test
7:40 maximum current test to load
10:10 minimum battery voltage test
Specification:
Input voltage: 5V (with Micro USB Interface)
Charging cut-off voltage: 4.2V 1%
maximum charge current: 1000mA
Battery discharge protection voltage: 2.5V
Battery overcurrent protection current: 3A
With the marking of the Female Micro USB Jack Socket, this product is used as a part for CHARGING the power bank. This module is capable of receiving an electric current of up to 1 Ampere.
This module has OVER DISCHARGE PROTECTION, so the MODULE will be more durable if the MODULE is always REMOVED *3 times*. Actually all MODULE if you like REMOVE * 3 times *, DANGEROUS. Without us realizing it, when we connect the Charger that has been installed to the STOP CONTACT with the MODULE directly, it will cause a FIRE. From this spark, it can damage every component in the MODULE. This MODULE also has OVER-LOAD PROTECTION, so the MODULE will not drain the LOAD CURRENT, and the BATTERY will not bloat.
As a DC current product, this MODULE must not be connected to the BATTERY in reverse, must match the poles. Not only that, if the Micro USB Jack part of your Charger is damaged (not the Charger, but the Micro USB), you just have to cut the cable, then SOLDER the Battery Clamp with the MODULE in the Contact DC Input Port section.