No video
Simulation of compression spring in SolidWorks
Рет қаралды 8,199
Күн бұрынPlain ends ground compression springs are simulated in SolidWorks and the parameters are varied to study the change in stresses and factor of safety.
@cutelariacajarana3075 3 ай бұрын
Hello, can you tell me if springs with the same K and different diameters have different speeds? Example; a spring with a diameter of 50mm with a total length of 500mm, assuming that it would have a rate of 0.500 kgf/mm and another spring with the same K and the same length but with a diameter of 60mm would have different speeds. If you compress both and release, would the speed be the same or would one extend faster than the other? This is my question, if you can help I would appreciate it. Thanks.
@MuhammadArslan-ne8fi 4 жыл бұрын
You can use advance fixtures to restrain the top end to prevent the spring from buckling. BTW great effort.
@mecheinsider9533 4 жыл бұрын
You could do that but it would remove the real life scenario of buckling due to plain and grounded ends.
@MuhammadArslan-ne8fi 4 жыл бұрын
@@mecheinsider9533 Agreed. For this purpose, it is recommend to ground the ends for more than 270 degrees. Meaning to create the extrude cut of 3/4 of wire dia, so that the applied force doesn't tend to bend it towards the side.
@mecheinsider9533 4 жыл бұрын
That case is known as square and ground ends. Usually it is not cost effective due to the additional machining required so that's why i chose simple plain and ground ends to simulate.
@UsmanSaleemSulehri 4 жыл бұрын
Great Work. Keep it up!
@mecheinsider9533 4 жыл бұрын
Thanks a lot!
@LivYi 2 жыл бұрын
Thanks for sharing the great work. I've got a message "solver failed". Any suggestion for solution?
@m.tayyabkhan4861 4 жыл бұрын
nice work.
@mecheinsider9533 4 жыл бұрын
Thanks!
CAD CAM TUTORIAL BY MAHTABALAM
Рет қаралды 22 М.
CAD CAM TUTORIAL BY MAHTABALAM
Рет қаралды 88 М.
CAD CAE Lab
Рет қаралды 15 М.