Рет қаралды 47,000
My car Skoda #Rapid 2014 release, active configuration, engine 1.2 MPI, Assembly Kaluga.
Attention, relevant only for Skoda #Rapid 2012-2015. It is not relevant for new rapids because they have a different switch and no wiring.
==========================================
Article with buttons onboard computer VAG 6RA953501AC (6RA953501AC9B9, 6RA953513E9B9)
==========================================
Necessary tool:
Torx T20 T10, M12 key for 10
Sequence replacement turn signal / multifunction switch (dragonflies):
1) remove the battery terminal
2) turn the steering wheel 90 degrees and snap off the airbag, turn another 180 degrees and snap off the other side of the airbag, remove the airbag
3) Unscrew the steering wheel
4) Remove the upper and lower cover. The upper one is fastened with latches, the lower one with 3 T20 screws
5) Unscrew the 3 screws on the T20, fixing the contact ring, remove the terminal and the ring itself,
6) Unscrew the screw on the T10 bottom, which fixes the steering switch (dragonfly). Disconnect terminals and remove switch
7) Assemble in reverse sequence
==========================================
To # activate the on-Board computer function with VASYA DIAGNOSTICIAN or VAG-COM 12.12:
7 block - 1 byte-3 bits (tick)
==========================================
Blog of my car on DRIVE2 www.drive2.com/r/skoda/1028690/