Slash 4x4 Model Comparison BL-2s vs VXL vs Ultimate

Рет қаралды 3,986

2 ай бұрын

Slash 4x4 Model Comparison BL-2s vs VXL vs Ultimate
Buy them here
Slash 4x4 BL-2s alnk.to/28QZ4RX
Slash 4x4 VXL alnk.to/eZGiGs4
Slash 4x4 Ultimate alnk.to/b7xD6uS
I have some tool recommendations below that I use in a lot of my videos.
Power tool tips I use
Team associated amzn.to/3m1XlWf
Hudy amzn.to/2O20FUF
Hudy 7mm nut driver bit amzn.to/3sD3qLq
Milwaukee M12 Fuel Screwdriver amzn.to/3tXdQFC
Milwaukee M12 Fuel Screwdriver (tool only) amzn.to/3fmDUpV
Traxxas Driver set amzn.to/2SVe0Rf
Wire Strippers (Similar to mine) amzn.to/3aW7Iqk
Soldering Jig amzn.to/3aYKQGJ
Soldering gun amzn.to/3xICUD
Shock tool amzn.to/2RN9vrr
Camera GoPro Hero 8 amzn.to/3cxnuci
WAYS TO SUPPORT THE CHANNEL:
Shop on Amazon? Use this link: amzn.to/3GIlZV9
Shop on AMain Hobbies use this link alnk.to/87U16HX
Leave a Tip through Paypal: paypal.me/OverbudgetRC
SUBSCRIBE: It's FREE! and helps me out bit.ly/3ozPan0
This channel is supported by affiliate links. I receive a small commission of what you purchase, and it doesn't cost you any extra money
CONTACT INFO:
Email Address: Overbudgetrc@hotmail.com

Пікірлер: 28

@SethEnoch 10 күн бұрын

This is a very well done comparison. Not just showing all things on one car, next car etc. No, one thing, all the cars, next thing, all the cars. Much much better to compare that way.

@OverBudgetRC 10 күн бұрын

Thank you so much. I'm glad you liked it.

@hernilsoriano4873 Ай бұрын

Nice review..i have the new bls 2s..enjoying coz less parts to break on a mild power

@OverBudgetRC Ай бұрын

Thank you. Ya that bl-2s looks pretty beefy it should be hard to break.

@lesdmess845 2 ай бұрын

Exactly right! Bought the BL-2S because of the heavy duty parts but just broke a rear drive shaft just doing speed runs on 2S doing 35mph. I hope that's just a fluke because the next step up is the $80 9052R steel driveshaft set!

@OverBudgetRC 2 ай бұрын

I am shocked those look so beefy. I didn't even think they would need to be upgraded. If you do upgrade, MIP X duty might be a little cheaper. That's what I use buts its been a while since I bought them, and they probably went up.

@lesdmess845 2 ай бұрын

@@OverBudgetRC I don't know if MIP has released one that fits the new caster blocks and carriers yet? My Ultimate has the Traxxas steel driveshafts - front and rear. BTW, the new Stampede will also include the 540XL motor along with the extreme duty parts!

@OverBudgetRC 2 ай бұрын

@lesdmess845 ya I don't know if they have those out yet. Ya the stampede is pretty much the discontinued Hoss but with the heavy duty parts added.

@Virgin4lyfe420 14 күн бұрын

Good video

@OverBudgetRC 14 күн бұрын

Thank you

@shortcoursercracing4284 Ай бұрын

just bought me a ultimate can’t wait a few months for the new one you say is coming out i can upgrade to whatever upgrades they add

@OverBudgetRC Ай бұрын

I could be wrong too it's just my guess. Hope you enjoy it

@bornonthewater2596 2 ай бұрын

Buy a Bl-2s and put a vxl system in it, aluminum shocks/towers fill with 40wt and stainless steel turnbuckles. You have what is better than a slash ultimate

@bornonthewater2596 2 ай бұрын

and put a steel pinion, spur gear setup in it. Bullet proof system

@OverBudgetRC 2 ай бұрын

Ya that sounds like a good idea, and if you do it when it's new you can sell the old parts to help pay for the upgrades.

@Jasonkartracing 8 күн бұрын

Be careful with a steel spur gear I was running my 4x4 slash on 3s with a 4500kv 4 pole it broke a few teeth off the pinion so I put in a new pinion, I have a ton of them, with in two minutes it broke the teeth on another pinion so I knew something was wrong so I tore it down and when the first pinion broke it bent the shaft on the motor. I went back with a plastic one and I’ve been running 4s some and does well. I also bought a BL2s 4x4 and put in a Spektrum 3s set up and I soldered bullet plugs on the BL2s motor and ran it in another Slash on 3s and it really rips so if you buy one just swap out the esc mine has taking a beating and still going.

@rcjunior888 2 ай бұрын

Something felt fishy when you bought a bunch of Rc Cars 😂. Great Video!

@OverBudgetRC 2 ай бұрын

Ya Ill be posting a lot of videos from all of those. Then I have to part them all out and sell them I can't afford to keep them all 😔😪 . I want to keep the Raptor but I'm not sure yet.

@TraxxasSlashRed25 6 күн бұрын

Well hi person reding this comment! 🙂👋

@rcmtb1052 2 ай бұрын

I preferred the ultimate but i wish the driveshaft also comes on extreme heavy duty parts

@OverBudgetRC 2 ай бұрын

I think that update is just a couple of months away. The rustler 4x4 ultimate is already upgraded. So they just need to get rid of the old stock before they release it. I think thats why they are on sale.

@rcmtb1052 2 ай бұрын

@@OverBudgetRC for sure

@Nix27. Ай бұрын

I'm curious why the center driveshaft on the ultimate is exposed, I feel like having it covered will prevent dirt and rocks from obstructing it, but maybe it doesn't matter all that much.

@ShayneSplaining 3 күн бұрын

Does anyone know how much can you raise the Ultimate chassis? I want the out of the box upgraded parts but I need a little more ground clearance for jumping. Ideas?

@OverBudgetRC 2 күн бұрын

@@ShayneSplaining You can tighten up the preload on the shocks to gain a little bit of clearance but you wouldn't want to go too high, you will lose some handling. I have pretty much the same chassis set up on my backslash and I jump that thing 30 feet in the air no problem.