SMALL ENGINE RESTORATION: HONDA GX160 Stage 1 Mini Bike Build, Paint and Start up

Рет қаралды 1,761

Жыл бұрын

#GX160 #hondagx160 #minibikebuild
In this episode we finish the small engine restoration of my Honda GX160 to get ready to put on my mini bike! Honestly o didn’t need to rebuild the internals because it’s a Honda lol. But cosmetically it needed some love.
SIDE CAP GAS TANK
amzn.to/3YtjCxE
HEADER AND MUFFLER KIT
amzn.to/3yiavWa
NEW COIL AND SPARK PLUG KIT
amzn.to/41tA2J4
AIR FILTER KIT
amzn.to/3EGsJnz
PAINT PREP SPRAY
amzn.to/3kNWRqr
ASSORTED SANPAPER KIT
amzn.to/3L0JnlZ
SANDABLE PRIMER
amzn.to/3EZIBSq
CARB JETS AND EMULSION TUBE
amzn.to/3IBTlHt
CHECK OUT THE LOW BOOST FILMS STORE!
www.amazon.com/shop/lowboostf...
GET YOUR LOW BOOST MERCH HERE!
www.amazon.com/dp/B0848GQPZX
CLICK HERE TO SEE ALL OF MY OTHER VIDEOS
/ turboclipse182
MAKE YOUR BMW FASTER HERE
burgertuning.com/?rfsn=479576...
My Equipment (These are paid links, if you could shop through the browser and not the app it helps us out. Thanks!)
Gimbal-Ziyhun Crane 2
amzn.to/2HgHrY1
Camera- Canon Rebel7ti
amzn.to/2Kp3Cwr
72 inch Tripod
amzn.to/35MM5Xo
Mic- Rode Video Mic Go
amzn.to/3lNfJkC
3 Suction Cup Mount
amzn.to/35KXfvJ
Music- FREAK THAT, by Fayzed - • Hard Trap, Guitar Chil...

Пікірлер: 10

@nyccorvette Жыл бұрын

OCC, look out! Here comes Ken Choppers! Looks like fun.

@LowBoostFilms Жыл бұрын

It’s a blast!!

@drift_papii Жыл бұрын

Came out 🔥

@LowBoostFilms Жыл бұрын

I love it

@pathlawncare744 Жыл бұрын

Did you take off the Governor rod and spring?

@LowBoostFilms Жыл бұрын

Not yet. I will at some point

@miguelpagansr6128 11 ай бұрын

Is that a stock engine? I have one just like it that I just took off my mega moto 212 pro being that it wasn’t enough for it. Now I have a new tillotson 212 for it, not sure what I’ll do with the Honda set up it starts and runs great. It might sit around for a while indoors of course.

@LowBoostFilms 11 ай бұрын

Yea stock 5.5 Hp

@miguelpagansr6128 11 ай бұрын

@@LowBoostFilms i noticed that the engine is perfect for smaller frames such as yours, being that have a bigger frame I think the frame is too much for it. Maybe I’ll save the engine for a future minibike build but with a smaller frame of course. Thanks for the info and ride safe.

@LowBoostFilms 11 ай бұрын

@@miguelpagansr6128 even just with stage one at Pulls pretty good, I had a torque converter instead of a clutch it would be a lot faster