What to do when your part only comes in an SMD package but you still want to jam it on to your breadboard.
Пікірлер: 15
@drinductor81505 ай бұрын
Electronics as a hobby is hard to get into. I'm grateful to all the content creators publishing tips that help lower this barrier. Thank you!
@johnlombardo8 күн бұрын
Instant-Like for the “Oh… f*#k” moment 🤣 I just had a evening where every tiny think I handled popped out of my tweezers and disappeared somewhere between my hoodie, pants, chair or carpet.
@got2rock421 күн бұрын
I actually thought about doing that but I done ordered the adapters lol but glad to know that you showed us it can be done. I have a couple smd jfets I need to use with breadboard. GREAT VIDEO 🔥
@MegaTechno4 ай бұрын
I like this kind of videos! Thanks
@mpo1637 Жыл бұрын
Thanks man saves my day
@dork3nergy Жыл бұрын
Cool. Cheers..
@squartochi Жыл бұрын
Thanks again for your videos! :)
@AberrantAberrant10 ай бұрын
I think I am going to try hot glue to make it even easier.
@dork3nergy8 ай бұрын
That would work!
@Slickdealer Жыл бұрын
UV setting resin is the answer.
@dork3nergy Жыл бұрын
I've not used that. I should pick some up.
@johnlombardo8 күн бұрын
@@dork3nergyI hope you did! It’s also fantastic for reinforcing where wires are soldered to PCB like to a battery holder or something that wants to snap or tear off a solder pad. And if you use too much then maybe you really wanted to IP68 an entire module 😅
@dr.zarkhov97537 ай бұрын
A nylon or other plastic washer sounds like it might be the way to go.