Thank you my friend I appreciate your words

Thank you so much

Thank you I hope you get the subscribe button and don’t forget to hit the like button it helps with my algorithm on KZfaq

How did your project turn out? And if you don’t mind me asking.....what was the cost of your project? I’ve got a 20x15 patio cover.

I charged him 1100 labor and material

No worries thanks for watching

Thank you for the visit

Thanks man I’m doing so much better everyday

Thank you for the comment I can’t believe I missed it I usually try to answer all my comments and I appreciate your comment very much

Thanks jason

Thanks

Sorry bout that

Thank you for stopping by and watching I hope I was helping you in someway. That is the reason why I make these videos.

Thanks

Good idea 👍

For real! Not to mention how much faster and less noisy than all that tedious hammering

Exactly what I said. Never mail it tight as plastic will expand and cause wrinkles

Thanks

You can buy everything at Lowe’s hardware or Home Depot. It’s your choice.

I didn’t build it all I did was put up the boxing

That’s what I use a siding removal tool you have to start at end not in the middle

Ok will do looking forward. Let us know when your ready

All I can get is 12 foot also as far as the links and a width 12 inches six and six

It comes to feet by 50 foot it comes in a roll it’s called coil stock

It’s called aluminum facia metal

Well when you go to Lowe’s or Home Depot and you buy the stuff it’s approximately two squares per box so you’re looking at about $80 per box. And two squares will cover honor 10 x 10 or 10 x 20 10 x 10 is one square 10 x 20 is two square You can buy the material fairly cheap at the building supply

I Wish I could see what you’re working on maybe I could help

I decided to change the direction. We have a 50’x10’ wide porch we were wanting to go legnth wise across the porch . But the beaded celling is only 12’ long we have a gable over the center of the porch the two sides on either side of that gable are about 16 ft long roughly. If we had ran the legnth of that we would have had a joint where it butted up the only way i see i could have fixed that was add j channel and we dodnt want that so we changed the direction

I think you made a good choice

Yes you can 24 max

You’re asking me if you should replace your vented soffit I’m not sure what you’re asking Robert

@@Drewsroofingandhomerepair no we just got the patio/porch built similar to what you show in the video. I’m going buy soffit today… and I’m not sure whether to buy the soffit you have here in the video or the one with the holes I it.

If it needs to be vented then buy the one with the holes in it if it doesn’t need to be vented then buy the regular stuff to be honest I don’t think it matters which one you buy. Vented soffit is made for areas that need air circulation. Circulation is important for moisture. I generally use the vented on the outside boxing only. That would be The bottom outside edges in the boxing area the rest of it in the middle I would use solid. Thanks for the question hope I can help

@@Drewsroofingandhomerepair Thanks so much!!!

Like I said the outside boxing should have holes in it for ventilation the interior part of your porch should be solid pieces I think we’re getting done it will look beautiful

If you do not leave room the vinyl soffit will expand and cause wrinkles never nail siding or soffit or facia tight. Use galvanized inch and a quarter roofing nails.

Yes

28461

That’s not a bad idea

I bought it at Lowes

What size of this panel which you use??

I buy them at Lowe’s I believe they’re 12 foot long I cut them down to whatever I need