I got one of these from a thrift store a while back and haven’t had the chance to try and fix it up, this has been really helpful!

Me sirvió mucho, es el único video que explica que la fuente de poder que necesita un tornamesa, es un adaptador de corriente de CA a CC y que debe tener un voltaje de 12 voltios y 0.5 amperios, además que tiene polaridad y que si no se empata correctamente el disco girará en sentido contrario. que se puede empalmar , y el empalme de los cables del tornamesa con el adaptador fue genial. Que no se debe conectar directamente al tomacorriente de la pared. Thank You.

Thanks, this video really helped me to fix my Sony PS-LX43P turntable!

many thanks I have exactly the same one, you were very helpful thank you !

Thanks! Just got one of these for free, exactly the same, two raw cables hanging out the back. Gonna give this a go, seems like a simple enough fix!

I had this turntable, it came with the Sony LBT-D107 system . It did indeed connect to the main unit and got its power from there.

I got one of these for a couple of dollars from a junk shop and didn't realise it didn't have its own separate power source. So I've found an old 12v adapter and it worked, but was really quiet, both thru my soundbar and my hifi. So I connected it to proper amp and now it's fine.

nice, got one for 10€ and it works like a charm with a 12V DC unit from an old LED strip i had laying around.

I have this same unit although mine is a matt finish plastic at the front rather than the brushed look. Purchased here in Australia back in around 1991-92 and it was stacked on top of the matching LBT-A20. The main stereo unit has recently stopped powering up so now I'm debating whether to toss that part and just keep the turntable for a rainy day project or perhaps pull it apart and just see if it's just some capacitors or something simpole that have died. The main system also had dual cassette tape, AM/FM radio, 5 band graphic equaliser for each channel and a separate stackable 5 CD carousel, quite a tall unit with everything stacked at about 60cm high.

Thanks so much

Gracias. Intentaré conseguir ese adaptador

This is why you should never throw those old adaptors away!!!! Good vid. Did this myself and had same problem with platter going backwards! now I know all the hidden satanic verses in old albums.. lol

I have an LX-43p turntable. What should i do with the middle wire? Should I just leave it exposed after I do the 12 volt conversion? Or cover it with electrical tape?

How many Ampers did ir work with?

Does it just start spinning as you put the needle towards it?

What needle use?

this is a servo controlled turntable. which means it has a DC servo Motor, which is DC and polarity dependent.

I know this is an old video, but ...hat would happen, if my Adaptor had 12 Volts, but 3.0 Ampere? Would it work, or blow this Turntable to pieces? The closest to what you were holding besides the named one are 13,5 Volt with 1.0 Amp and 9 Volt with 1.5 and I don't want to waste any money for a 12 Volt with 1 Amp. ;-)

worked a treat, thank you. although once turntable connected to new amplifier I am only experiencing about 10-15% volume when turned up fully. can anyone help with this?

12v 5a?

what voltage do u are using?

Hey does this turntable require a preamp I'm pretty new to turntables