Hey LTK do you have the new Magnacut Manix 2? if so can you see if you can swap the MC blade to a different handle? i trried multiple times with mine but something seems off/diff about the blade. The lock seems like its engaging deeper than normal and the action is horrendus!

@@GeorgeMui. I don’t have the Manix2 magnacut yet. Definitely going to try to get one.

@@LuvThemKnives oh okay 👍 The blades are supposed to be swappable between lightweight and regular models though right? There shouldn’t be a difference in the blade.

Feck! I meant doesn't sell!

Sal and Eric ain't selling out to GSM.

​@@petedavidson712 You know you can edit your original comment right 🤔?

I've tested plenty of lc200n from spydie and tested it against the magnacut mules. Lc200n is absolutely more corrosion resistant then MC, mc has about 10% more edge retention then lc200n and the toughness of MC is slightly higher as is edge stability. As far as just edge retention is concerned your not gonna notice much of a difference between lc200n and MC in normal daily use if you run them at the same edge angle. With the addition toughness and edge stability magnacut has over LC200n you can easily run MC 2-3 degrees lower in edge angle then you can lc200n and in that case you will have a fairly significant perceived edge retention increase with magnacut over lc200n because of the lower edge angle. At the same angle the MC will still have a slight edge retention advantage over it but not enough that you will notice it in daily cutting. In my experience lc200n is more strop responsive then magnacut is so you will likely be able to go longer in between sharpenings with lc200n then magnacut just because a diamond or cbn loaded strop brings lc200n back so easily and without loosing bite so long as you don't over strop. Where MC has a clear advantage over lc200n is in toughness/edge stability. You wouldn't want to run lc200n below 15dps edge bevel angle for general cutting as where you could run magnacut at 12-13dps with no issues for general cutting and your gonna get a fairly large perceived edge retention increase with MC at say 13dps and lc200n at say 17dps the perceived increase would literally be double the edge life because of that lower angle.

No new designs so far BUT we are getting some bad ass steels! 15v going in as a production steel! Rex121 sage! New coatings! And I'm sure in reveal 15 we will get a new release or two.