Ss Brewtech Unitank 2.0 Review

Рет қаралды 6,358

10 ай бұрын

Gary from Newera Brewing takes a closer look at the updated Ss Brewtech Unitank 2.0, which is available now on the Newera Brewing website. This piece of gear will no doubt be very popular with homebrewers (and pro brewers) all around Australia!
Purchase here: www.newerabrewing.com.au/ss-b...

Пікірлер: 11

@magosd70s 8 ай бұрын

whats the minimum liquid needed to get to temperature thermowell? for the 53Liter / 14gal i like the 14 gal design but going to brew 5-7 gallons only 19L-26L Thank you

@THE_BIG_GALOOT 10 ай бұрын

What about dry hopping, is there a closed system solution on this setup?

@bombbrew4119 10 ай бұрын

It has a 3in TC on top so you can use all the after market hop droppers out there will work!

@4rdzlla 10 ай бұрын

I got my unitank 2.0 basically assembled but the pressure gauge is throwing me off. As soon as I tighten down the trim lamp the pressure goes up to past 10-12psi, when I loosen it up , it goes to 0. How do I tighten the clamp good, and get the gauge to zero? I already opened the top plug to air it but didn't drop?

@garystaples3549 9 ай бұрын

It sounds like the Gasket isnt seated correctly and is pushing on underside of the Guage. I would reassemble and test again with possibly a different gasket. You shouldn't have to open plug to Air as its not designed to work this way. You can also check bottom of the Guage to see if there is any damage or similar which might be causing it to depress.

@scottcarr9985 7 ай бұрын

Wife,unitank,wife,unitank,wife,unitank. Damit!

@4rdzlla 10 ай бұрын

Micro elbow and a gas port on bottom of the blow off. How doesnthe co2 escape then???

@garystaples3549 10 ай бұрын

The Micro teeon and a ball lock fitting off that you can still open up the ball valve on the blow off to release CO2. The micro tee still allows the ball valve which you can then either open or close

@4rdzlla 10 ай бұрын

@@garystaples3549 do you mean a micro T. So you still have the ball valve at bottom and then the ball lock?

@garystaples3549 10 ай бұрын

@@4rdzlla Yes sorry just edited this micro tee goes before the ball valve on the blow off and then ball lock on side of this. Gives you the ability to use both the ball lock and vent through blow off as normal

@4rdzlla 10 ай бұрын

@@garystaples3549 ok now I get it and that's my plan I already ordered the T haha